User manual MAXTOR MEDALIST 545XE INSTALLATION

[. . . ] INSTALLING YOUR NEW SEAGATE HARD DRIVE HANDLE WITH CARE! Disc drives are extremely fragile. Do not drop or jar your drive. WHAT YOU WILL NEED MEDALIST HARD DRIVE INSTALLATION GUIDE Medalist 545xe (ST3660A) Medalist 630xe (ST3630A) for ATA (IDE)-Compatible PCs Thank you for selecting a Seagate hard drive. Installing your new Seagate hard drive is easy when you use this easy drive-installation sheet. For technical information and troubleshooting tips, see the back of this sheet. [. . . ] If you agree to the terms, select Accept Agreement to continue. The next screen lists the features the SEG32BIT. 386 driver supports. If your computer supports these features, they will be active in 32-bit disk access mode with SEG32BIT. 386 for all drives that support them. Select Install Driver to continue. · Check for I/O address conflicts. To isolate the conflict, verify that the drive and host adapter are compatible with your computer by removing all the peripheral adapter cards (power must be off) except for the video card. Reinstall the drive and host adapter card and boot the computer. If this is successful, reinstall the other peripherals one at a time until the conflict occurs. After you have isolated the source of the address conflict, you can resolve the conflict by changing the I/O address of the peripheral that appears to cause the conflict. To make the feature active, you must enable the 32-bit disk access option in the Windows control panel. Select Use 32-Bit Disk Access (an X in the box enables the feature). Save the change. · If you are booting from a diskette and Disk Manager installed your drive using DDO, the information in the boot record for the drive was not loaded. Make sure there is not a diskette in Drive A and reboot. If you want to boot with the diskette, follow the "Booting with a Diskette" instructions in column one. ADDITIONAL INSTALLATION OPTIONS The options jumper block is used to configure your Seagate drive to work with other drives on the controller. It allows you to configure the drive for systems that use cable-select interconnection and provides options you can try if your computer does not recognize the slave after startup. The dealer partitioned and formatted the drive for you in the store, but the drive does not respond when you install it. SeaFAX You can use a touch-tone telephone to access Seagate's automated FAX system to receive technical support information by return FAX. This service is available 24 hours daily. Location United States England Telephone number 408-438-2620 44-1-62-847-7080 Removing the Dynamic Drive Overlay If Disk Manager installs your drive with DDO, you can, in many cases, remove DDO without losing your data. However, you will lose access to the full capacity of your drive unless you use another method that supports more than 528 Mbytes (see "Accessing More Than 528 Mbytes" on the front side). Three steps are required to remove DDO safely: 1) migrating the data, 2) configuring Setup with the drives's translation and 3) uninstalling DDO. Follow the instructions below to remove DDO safely. · Reboot the computer and make sure the drive spins up. Check all cables. · Make sure the power supply has adequate power for your system. · Make sure the DOS version the dealer used to partition and format the drive is the same version you have installed on your computer. If it isn't, see your dealer. Systems Using Cable Select Some computers differentiate between master and slave drives using specially designed interface cables that have the line to pin 28 (the Cable Select pin) removed or cut at one end. The connector that has pin 28 disabled is used for the slave drive. [. . . ] Alle Arbeiten auf dem Festplatte dürfen nur von Ausgebildetem Servicepersonal durchgeführt werden. Bitte schaffen Sie Festplatteetiketten nicht weg. Der Einbaudes Drives muss den Anforderungen gemäss DIN IEC 950V DC 0805/05. 90 entsprechen. Seagate, Seagate Technology, SeaFAX, SeaFONE, SeaBOARD and the Seagate logo are registered trademarks of Seagate Technology, Inc. [. . . ]