User manual MAXTOR MEDIALIST 2140 INSTALLATION

[. . . ] INSTALLING YOUR NEW SEAGATE HARD DRIVE HANDLE WITH CARE! Disc drives are extremely fragile. Do not drop or jar your drive. WHAT YOU WILL NEED MEDALIST HARD DRIVE INSTALLATION GUIDE for ATA (IDE)-Compatible PCs Medalist 2140 (ST32140A) Medalist 1640 (ST31640A) Thank you for selecting a Seagate disc drive. Installing your new Seagate hard drive is easy when you use this easy drive installation sheet. For technical information and troubleshooting tips, see the back of this sheet. [. . . ] 1 Insert the original diskette into Drive A and access the drive. The computer will read the original diskette and prompt you to insert the destination diskette into Drive A. 3 Insert a blank diskette into Drive A and press any key. Erase the files you need to replace on the copy diskette, and copy the replacement files using the standard copy command. (If only one diskette drive is available for copying, first copy the required files to the hard drive from the appropriate subdirectory, then copy the files to your new diskette. ) to the terms, select Accept Agreement to continue. 6 The next screen lists the features the SEG32BIT. 386 driver supports. If your computer supports these features, they will be active in 32-bit disk access mode with SEG32BIT. 386 for all drives that support them. To make the feature active, you must enable the 32-bit disk access option in the Windows control panel. Select Use 32-Bit Disk Access (an X in the box enables the feature). Save the change. · Check for I/O address conflicts. To isolate the conflict, verify that the drive and host adapter are compatible with your computer by removing all the peripheral adapter cards (power must be off) except for the video card. Reinstall the drive and host adapter card and boot the computer. If this is successful, reinstall the other peripherals one at a time until the conflict occurs. After you have isolated the source of the address conflict, you can resolve the conflict by changing the I/O address of the peripheral that appears to cause the conflict. SeaFAX You can use a touch-tone telephone to access Seagate's automated FAX system to receive technical support information by return FAX. This service is available 24 hours daily. Location United States England Telephone number 408-438-2620 44-1-62-847-7080 ADDITIONAL INSTALLATION OPTIONS The options jumper block allows you to configure your Seagate drive for ATA MS (master/slave timing), cable select and a remote LED. The drawing below shows you how to configure the drive for each option. A brief description of each option follows the drawing. · If you are booting from a diskette and Disk Manager installed your drive using DDO, the information in the boot record for the drive was not loaded. Make sure there is not a diskette in Drive A and reboot. If you want to boot with the diskette, follow the "Booting with a Diskette" instructions in column one. Removing the Dynamic Drive Overlay If Disk Manager installs your drive with DDO, you can, in many cases, remove DDO without losing your data. However, you will lose access to the full capacity of your drive unless you use another method that supports more than 528 Mbytes (see "Accessing more than 528 Mbytes" on the front side). Three steps are required to remove DDO safely: 1) migrating the data, 2) configuring Setup with the drives's translation and 3) uninstalling the DDO. Follow the instructions below to safely remove the DDO. The dealer partitioned and formatted the drive for you in the store but the drive does not respond when you install it. SeaFAX document numbers are indicated by this symbol throughout this installation guide. · Reboot the computer and make sure the drive spins up. Check all cables. · Make sure the power supply is adequate for system needs. [. . . ] Other names are registered trademarks or trademarks of their owners. Seagate reserves the right to change, without notice, product offerings or specifications. No part of this publication may be reproduced in any form without written permission from Seagate Technology, Inc. 920 Disc Drive, Scotts Valley, CA 95066, USA Publication Number: 36351-101, Rev. [. . . ]