User manual MAXTOR MOMENTUS 7200 FDE.2 SATA REV B 9-2009

[. . . ] Product Manual Momentus 7200 FDE. 2 SATA ® ST9500422AS ST9500421AS ST9320426AS ST9250412AS ST9250411AS ST9160413AS ST9500426ASG ST9320427ASG ST9320426ASG ST9250464ASG ST9250414ASG ST9160419ASG ST9160418ASG 100571983 Rev. B September 2009 ©2009, Seagate Technology LLC All rights reserved. B September 2009 Seagate, Seagate Technology and the Wave logo are registered trademarks of Seagate Technology LLC in the United States and/or other countries. Momentus, SeaTools and SeaTDD are either trademarks or registered trademarks of Seagate Technology LLC or one of its affiliated companies in the United States and/or other countries. [. . . ] Seagate is not responsible for lost or stolen authentication data such as passwords, user names, domain names, or any authentication data perceived to be inoperative, and as a consequence of lost or stolen passwords, user names, or domain names, Seagate cannot be held liable for data that cannot be retrieved from the drive due to inability to authenticate the user to the drive as required by the security pre-boot software. 3. 1 Handling and static-discharge precautions After unpacking, and before installation, the drive may be exposed to potential handling and electrostatic discharge (ESD) hazards. Observe the following standard handling and static-discharge precautions: Caution: · Keep the drive in the electrostatic discharge (ESD) bag until you are ready for installation to limit the drive's exposure to ESD. · Before handling the drive, put on a grounded wrist strap, or ground yourself frequently by touching the metal chassis of a computer that is plugged into a grounded outlet. Wear a grounded wrist strap throughout the entire installation procedure. · Handle the drive only by its edges or frame. · The drive is fragile--handle it with care. Do not press down on the drive top cover. · Always rest the drive on a padded, antistatic surface until you mount it in the computer. · Do not touch the connector pins or the printed circuit board. · Do not remove the factory-installed labels from the drive or cover them with additional labels. Some factory-installed labels contain information needed to service the drive. Other labels are used to seal out dirt and contamination. Momentus 7200 FDE. 2 SATA Product Manual, Rev. B 19 · Do not obstruct the breather hole located on the top cover of the drive. Refer to Figure 4 for the exact location of this hole. 3. 2 Configuring the drive Each drive on the Serial ATA interface connects in a point-to-point configuration with the Serial ATA host adapter. There is no master/slave relationship because each drive is considered a master in a point-to-point relationships. If two drives are attached on one Serial ATA host adapter, the host operating system views the two devices as if they were both "masters" on two separate ports. This means both drives behave as if they are Device 0 (master) devices. Serial ATA drives are designed for easy installation with no jumpers, terminators, or other settings. It is not necessary to set any jumpers on this drive for proper operation. The jumper block adjacent to the signal connector is for factory use only. 3. 0 Gbits per second operation Limit data transfer rate to 1. 5 Gbits per second Jumper block SATA power connector SATA interface connector Figure 2. Serial ATA connectors 3. 3 Serial ATA cables and connectors The Serial ATA interface cable consists of four conductors in two differential pairs, plus three ground connections. The cable size may be 30 to 26 AWG with a maximum length of one meter (39. 37 inches). [. . . ] Exceptions to the specifications for the Momentus 7200 FDE. 2 SATA drives are listed in Section 4. 0. 46 Momentus 7200 FDE. 2 SATA Product Manual, Rev. B 6. 0 Seagate Technology support services Internet For information regarding Seagate products and services, visit www. seagate. com. Worldwide support is available 24 hours daily by email for your questions. Presales Support: Presales@Seagate. com Technical Support: DiscSupport@Seagate. com Warranty Support: http://www. seagate. com/www/en-us/support/warranty_&_returns_assistance mySeagate my. seagate. com is the industry's first Web portal designed specifically for OEMs and distributors. [. . . ]