User manual MAYTAG MSE 661

[. . . ] Use & Care Guide Dishwasher MAYTAG MSE 661 Quick Guide 1. Loading the baskets Remove large food particles and debris. There is no need to rinse thanks to the Super Cleaning SystemTM. 2. Dispensing dishwasher detergent The detergent compartment has a small compartment for pre-wash and one for main wash. 3. [. . . ] Machines with refill indicator There is a refill indicator in the middle of the dispenser (see picture). If the refill indicator is totally black, there is sufficient rinse aid. However, if the indicator has a more transparent appearance, you need to top up with rinse aid (see above). Open Refill indicator Closed Cover for rinse aid Open by turning and lifting the cover! 20 Salt Pour in salt (applies to dishwashers with water softeners) Before using a dishwasher with a water softening filter, you must fill the salt compartment with salt. Use coarse salt or special salt for dishwashers. It is best to fill with salt when you are about to do a wash, as the dishwasher needs to be rinsed out immediately after filling. Place the funnel, which is supplied with the dishwasher, into the compartment's filler hole. First pour in approximately 1 litre of water. Then fill the compartment with max 1. 5 kg salt. Wipe away excess salt so that the cover can be properly screwed into place. Run a Normal wash program so that any salt in the machine is rinsed away. When the salt runs out, unscrew the cover and fill the compartment with salt. Water is only needed on the first occasion!Run a Normal wash program so that any salt is rinsed away. Occasionally check to see if more salt is needed. A green indicator can be seen in the cover of the salt compartment. Cover for the salt compartment CAUTION! Never pour dishwasher detergent into the salt compartment. The water softener will be ruined! 21 Settings Setting water hardness If you have a dishwasher with a water softener, you may need to change the setting depending on the water's hardness level. Phone your local Water Board to check the water hardness in your area. The dishwasher is set for low water hardness on delivery. L2 L3 L12 L7 L1 L4 L11 L8 L6 L5 L10 L9 1. Switch off the dishwasher with the main switch. Press the main switch while holding in the Start/Stop button. Release both buttons and the L7 light will flash. Select desired setting (see table below) by pressing repeatedly on the Program button. Setting All extinguished L1 lit L1, L2 lit L1, L2, L3 lit L1, L2, L3, L4 lit L1, L2, L3, L4, L5, L11 lit °dH 0-5* 6-8 9-14 °fH 0-9* 9-14 15-25 15-19 26-34 20-29 35-52 30-44 53-79 80 and up L1, L2, L3, L4, 45 and L5, L6, L11, up L12 lit 5. [. . . ] The taller one should be used if the machine is to be 850 - 870 mm high and the depth of the plinth can be varied between 45 - 105 mm. The lower one is to be used if the machine will be 820 - 845 mm with a plinth depth of between 50 - 105 mm. Attach the enclosed felt insulation to the kickplate (some models). Set the correct plinth depth as follows: 1. [. . . ]