User manual MAYTAG MSE 860 FARS

[. . . ] Use & Care Guide Dishwasher MAYTAG MSE 860 FARS Quick Guide 1. Loading baskets Remove large food particles and debris. There is no need to rinse thanks to the Super Cleaning SystemTM. 2. Dispensing dishwasher detergent The detergent compartment has a small compartment for pre-wash and one for main wash. 3. [. . . ] It's possible, by inserting your finger in the hole, to turn the pump impeller and remove any blockage. Insert the plug in the wall socket. Adapting piece 21 If you still cannot start the machine and a humming noise can be heard, then the overfilling protection has been activated. · Shutoff the water · Remove the plug from the wall socket · Call Service CAUTION! Do not forget to replace the adapting piece. Spray arms The holes and bearings can occasionally become clogged. Pull the lower spray arm straight up to release it. Scrape away the debris with a needle or similar. The spray arms also have holes on the underside. To release the upper spray arm, the upper basket must be removed. Pull out the basket and turn the basket stop outwards on both rails (see picture). Remove the upper spray arm in the same way as the lower arm and clean it. Door When cleaning the edge around the door, use only a slightly damp cloth, possibly with a little detergent. Do not use a spray bottle or similar around the door catch. This is to ensure that water does not penetrate into the door catch and come into contact with the electrical components. CAUTION! Do not use a spray bottle or similar around the door catch. Tip! In order to prevent bad odours in the dishwasher, clean the strips and corners with a dish brush and low-lather detergent. 22 Rinse aid Pour in rinse aid Drying proceeds more quickly if you use rinse aid. Machines with indicator on the panel When the rinse aid has run out and more is needed, the rinse aid symbol on the panel lights up*. Turn and lift up the cover of the rinse aid compartment to the right of the dispenser. This is where you top up and set the amount of rinse aid to be dispensed in each wash. Carefully pour in rinse aid up to the knob for dosage setting. Do not forget to close the cover. Select dosage The dispenser is usually set at 1= soft water. However, depending on the water hardness, it may be necessary to change the dosage. Here you will find the dispenser's adjustment dial. Settings 1-6: the harder the water, the higher the dosage. When the water hardness exceeds 10-12 odH you should use rinse aid with citric acid (acid rinse aid) if the machine does not have a water softening filter. If the machine has a water softening filter, dispense as for soft water. Too much rinse aid can lead to the build-up of foam. [. . . ] Set the correct plinth depth as follows: 1. Press the grey catches towards each other and pull out the holders as far as required. Press in the catches so that they lock the brackets in place. Hang the kick-plate onto the holders by inserting it into the grooves. Fitting strip seal (on the floorplinth covering plate) Proceed as follows: 1. [. . . ]