User manual MC CULLOCH CS450 ELITE

[. . . ] the machine’s emission is specified in chapter Technical data and on label. Both of the operator′s hands must be used to operate the chain saw. Other symbols/decals on the machine refer to special certification requirements for certain markets. Symbols in the operator’s manual: Switch off the engine by moving the stop switch to the STOP position before carrying out any checks or maintenance. [. . . ] (22) Pull the starter handle, 4: Pull the starter handle with your right hand and pull out the starter cord slowly until you feel a resistance (as the starter pawls engage) then pull firmly and rapidly until the engine fires. Push down the red choke control, 5: As soon as the engine fires which can be heard through a "puff" sound, push down on the red choke control. Pull the starter handle, 6: Keep on pulling the cord powerfully until the engine starts. Warm engine CS 410 Elite Keep people and animals well away from the working area. Never twist the starter cord around your hand. Start position, 1: The correct choke/start throttle setting for warm starting is obtained by initially moving the choke control by pulling the red control outward - upwards. (21) Air purge, 2: Press the air purge diaphragm repeatedly until fuel fills the diaphragm (at least 6 times). The diaphragm need not be completely filled. (21) Push down the red choke control, 4: This inactivates the choke, which is not needed when starting a warm chain saw. However the movement of the start/stop switch will have engaged a high idle, making warm starting easier. Pull the starter handle, 5: Grip the front handle with your left hand. (22) Pull the starter handle, 3: Pull the starter handle with your right hand and pull out the starter cord slowly until you feel a resistance (as the starter pawls engage) then pull firmly and rapidly until the engine fires. Push down the red choke control, 4: As soon as the engine fires which can be heard through a "puff" sound, push down on the red choke control. Pull the starter handle, 5: Keep on pulling the cord powerfully until the engine starts. CS 450 Elite Start position, 1: Set the start/stop switch in the choke position by pulling the red control outward - upward. (23) Decompression valve, 2: Press the valve to reduce the pressure in the cylinder and make starting easier. Once the machine has started the valve will automatically return to its original setting. (23) English – 19 STARTING AND STOPPING As the chain brake is still engaged the speed of the engine must be set to idling as soon as possible, this is achieved by disengaging the throttle lock. Disengagement is done by gently touching on the throttle trigger. This prevents unnecessary wear to the clutch, clutch drum and brake band. Allow the machine to idle a few seconds before giving full throttle. (24) There is a simplified start reminder with illustrations to describe each step on the rear edge of the saw. [. . . ] Check the fuel filter and the fuel hose. Empty the fuel tank and clean the inside. Empty the oil tank and clean the inside. 28 – English TECHNICAL DATA Technical data CS 410 Elite Engine Cylinder displacement, cm3 Cylinder bore, mm Stroke, mm Idle speed, rpm Power, kW Ignition system Spark plug Electrode gap, mm Fuel and lubrication system Fuel tank capacity, litre Oil pump capacity at 9, 000 rpm, ml/min Oil tank capacity, litre Type of oil pump Weight Chain saw without bar or chain, empty tanks, kg Noise emissions (see note 1) Sound power level, measured dB(A) Sound power level, guaranteed LWA dB(A) Sound levels (see note 2) Equivalent sound pressure level at the operator’s ear, 103 dB(A) Equivalent vibration levels, a hveq (see note 3) Front handle, m/s2 Rear handle, m/s2 Chain/bar Standard bar length, inch/cm Recommended bar lengths, inch/cm Usable cutting length, inch/cm Pitch, inch/mm Thickness of drive links, inch/mm Type of drive sprocket/number of teeth Chain speed at max. [. . . ]