User manual MC CULLOCH CSE 1835

[. . . ] Always grip the machine with two hands Kickback danger Protective goggles or visor, protective helmet and hearing protection Do not expose to rain or moisture. Chain oil Protective cut-proof gloves Protective long, cut-proof trousers Chain brake: deactivated, activated Remove plug from the mains immediately if the cable is damaged or cut 10 m Refrain from Turn the machine off Disconnect the plug before adjusting or cleaning. Risk of electric shock d) Keep bystanders away General Power Tool Safety Warnings instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. [. . . ] When the machine is used with the bar in horizontal position, for example during tree felling, the chain brake offers less protection. ASSEMBLY / DISASSEMBLY Assembly methods change according to the type of your machine- so please take care to refer to the illustrations and machine type marked on the label. Take great care when assembling to ensure this is performed correctly. Check that the chain brake is not activated. Unscrew the bar retaining nut and remove the 2b. 3 Position the chain over the bar, starting at the nose sprocket, fitting into the bar guide groove. Ensure that the sharp side of the cutting teeth face in a frontward direction on the upper part of the bar. Ensure the chain tensioner pin is as far back towards the drive sprocket as possible. Mount the bar on the bar retaining screw and the chain tensioner pin and position the chain over the drive sprocket. Replace the drive sprocket cover, ensuring the drive teeth of the chain are engaged in the drive sprocket and in the guide groove. Screw the bar retaining nut by hand until loosely 5b. Choice of chain oil Always use new oil only (special type for chains) with adequate viscosity: the oil must adhere well and guarantee good running properties in both winter and summer. If chain oil is not available, EP 90 transmission oil can be used. Filling oil tank Unscrew the oil tank cap, and fill the tank taking care not to spill any oil (if this occurs clean the machine carefully) and then screw the cap back on tightly. Before performing any maintenance or cleaning, remove the plug from the mains. In cases where work environments are particularly dirty or dusty, the operations described must be performed more frequently than mentioned in the instructions. MAINTENANCE AND STORAGE Check that the chain oil pump functions correctly: direct the bar towards a clear surface at a distance of about 20 centimetres; after the machine has run for about a minute, the surface should show clear traces of oil (fig. Check that excessive strength is not needed for activating and deactivating the chain brake. Also check that it is not activated too easily and that it is not blocked. Then check chain brake function as follows: release the chain brake, grip the machine correctly and start up the machine, activate the chain brake by pushing the front hand guard forward with the left wrist or arm but without removing the hand from the handle (fig. If the chain brake is working correctly, the chain should be stopped immediately. Check that the chain is sharpened correctly, in good working condition and that the tension is correct. [. . . ] For mer detaljert informasjon om gjenvinning av dette produktet, vennligst ta kontakt med kommunekontoret på stedet, renovasjonstjenesten for husholdningsavfall, eller butikken hvor du kjøpte produktet. Operatører skal sørge for sikkerhetstiltak for å beskytte seg selv som er basert på beregnet eksponering under faktiske bruksforhold (hvor det tas hensyn til alle deler av brukssyklusen slik som tiden når verktøyet er slått av og når det går på tomgang i tillegg til avtrekkertid). Skru festemutteren for stanga løst til for hånd. Skru festeknotten for stanga løst til for hånd. [. . . ]