User manual MC CULLOCH M105-85F

[. . . ] M11577RB Instruction manual Please read these instructions carefully and make sure you understand them before using this machine. Prezechowywanie Uskladnenie Tárolás 3 18 31 39 41 49 78 81 We reserve the right to make changes without prior notice. Safe Operation Practices for Ride-On Mowers I. tRAINING Read the instructions carefully. [. . . ] USING THE ROS • Depress clutch/brake pedal all the way down and hold. € With engine running, turn ignition key counterclockwise to ROS "ON" position. • Move gear shift lever to reverse (R) position and slowly release clutch/brake pedal to start movement. € When use of the ROS is no longer needed, turn the ignition key clockwise to engine "ON" position. € • • • Cutting tips Clear the lawn from stones and other objects which can be thrown away by the blades. localize and mark stones and other fixed objects to avoid collision. Begin with a high cutting height and reduce until the required cutting result is obtained. The cutting result is best with high engine speed (blades rotate quickly) and low gear (machine goes slowly). If the grass is not too long and thick the drive speed can be increased by selecting a higher gear or increasing the motor speed, without affecting the cutting result. The best lawn is achieved if the grass is cut often. Cutting becomes more even and the cut grass is more evenly distributed over the surface. Total time taken is not greater, since higher drive speed can be selected without affecting the cutting results. The cutting results will be worse since the wheels will sink into the soft lawn. Spray the cutting unit with water underneath after use. € • • Do not drive in terrain at an angle of more than max. The risk for roll-over backwards is large. In steep terrain the risk for tipping is considerable. 47 5 Switching off the engine Move the attachment clutch control to disengaged position. Move the throttle control between half and full speed (fast) position. Lift up the cutting unit and turn the ignition key to “STOP” position. Do not leave the ignition key in the machine when not in use to prevent children and other unauthorized persons starting the engine. Before servicing the engine or cutting unit the following shall be carried out: • Press down the clutch/brake pedal and engage the parking brake lever. [. . . ] WARNING: A broken or missing washout fitting could expose you or others to thrown objects from contact with the blade. Replace broken or missing washout fitting immediately, prior to using mower again. Plug any holes in mower with bolts and locknuts. € • • • 76 6 Replacement of drive belt Dismantle the cutting unit as described previously Engage the parking brake and work off the belt upwards from the pulley (1), the clutch pulley (2) and the engine's drive wheel (3). [. . . ]