User manual MC CULLOCH M13097RB

[. . . ] M130-97RB Instruction manual Please read these instructions carefully and make sure you understand them before using this machine. Prezechowywanie Uskladnenie Tárolás 3 18 33 40 42 54 86 89 We reserve the right to make changes without prior notice. Safety Rules Safe Operation Practices for Ride-On Mowers IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWING OBJECTS. Be familiar with the controls and the proper use of the equipment. [. . . ] Begin with a high cutting height and reduce until the required cutting result is obtained. The cutting result is best with high engine speed (blades rotate quickly) and low gear (machine goes slowly). If the grass is not too long and thick the drive speed can be increased by selecting a higher gear or increasing the motor speed, without affecting the cutting result. The best lawn is achieved if the grass is cut often. Cutting becomes more even and the cut grass is more evenly distributed over the surface. Total time taken is not greater, since higher drive speed can be selected without affecting the cutting results. The cutting results will be worse since the wheels will sink into the soft lawn. Spray the cutting unit with water underneath after use. € • • • • • 48 5 To convert mower: (Converting to mulching or rear discharging will require the purchase of these accessories. ) To mulching Place deck into the high cut position. remove bagger or optional rear discharge deflector. Insert plug assembly through back plate and into the mower deck chute adaptor. € Retain the plug assembly by connecting the two straps into the holes provided on the bagger support arms. • Replace bagger or optional rear discharge deflector to allow mower to operate. € • • To rear discharging • Place deck into the high cut position. € Attach the chute by applying the two wingnuts to the flange of the chute. € Install the discharge deflector to the backplate by screwing the four (4) wing screws into the threaded inserts located in the backplate. • Tighten the wing screws securely. To bagging • Place deck into the high cut position. • Remove the rear discharge deflector or mulching plug. € Insert the discharge chute into the opening in the backplate and onto the mower deck adaptor. € Attach the chute to the tractor by applying the two wingnuts to the flange of the chute. [. . . ] Turn the ignition key to the STOP position to turn the tractor’s engine off. € Pull back the lock collar of the nozzle adapter to disconnect the adapter from the nozzle washout port. € Move the tractor to a dry area, preferably a concrete or paved area. Place the attachment clutch control in the “Engaged” position to remove excess water and to help dry before putting the tractor away. [. . . ]