User manual MC CULLOCH MOWCART

[. . . ] Biz MOWCART Instruction manual Please read these instructions carefully and make sure you understand them before using this machine. 3 18 22 29 31 39 62 65 We reserve the right to make changes without prior notice. Safety rules Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWING OBJECTS. fAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. [. . . ] If the engine will not start, wait about 10 seconds before the next try. Let the ignition key return to the ”ON” position when the engine has started. Driving Lower the mower deck by moving the height adjustment lever (1) forward. engage mower blade by moving the deck clutch lever (2) forward. Choose a driving speed which suits the terrain and required cutting results. Any attempt by the operator to travel in the reverse direction with the deck clutch engaged will shut off the engine unless ignition key is placed in the ROS "ON" position. WARNING: Backing up with the deck clutch engaged while mowing is strongly discouraged. Turning the ROS "ON", to allow reverse operation with the deck clutch engaged, should only be done when the operator decides it is necessary to reposition the machine with the attachment engaged. Do not mow in reverse unless absolutely necessary. USING THE REVERSE OPERATION SYSTEM Only use if you are certain no children or other bystanders will enter the mowing area. • Move motion control lever to neutral (N) position. € With engine running, turn ignition key counterclockwise to ROS "ON" position. € Look down and behind before and while backing. • Slowly move motion control lever to reverse (R) position to start movement. € When use of the ROS is no longer needed, turn the ignition key clockwise to engine "ON" position. 35 5 Cutting tips • • • • • Clear the lawn from stones and other objects which can be thrown away by the blades. localize and mark stones and other fixed objects to avoid collision. Begin with a high cutting height and reduce until the required cutting result is obtained. If the grass is not too long and thick the drive speed can be increased by selecting a higher gear without affecting the cutting result. The best lawn is achieved if the grass is cut often. Cutting becomes more even and the cut grass is more evenly distributed over the surface. Total time taken is not greater, since higher drive speed can be selected without affecting the cutting results. [. . . ] € Remove dust cover (1), retaining ring (2), and washer (3) to allow wheel removal. € Remove dust cover (1), retaining ring (2), washer (3), and square key (4) while pulling tire off. € Replace square key while putting tire back on, then replace washer and retaining ring securely in axle groove , when pushing tire back onto shaft reach under and pull chain sprocket toward you to ease tire replacement. TO ADJUST STEERING WHEEL ALIGNMENT If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, adjust steering wheel alignment. [. . . ]