User manual MCCULLOCH 1600 GARDENVAC

[. . . ] FO T IN AN nce O RT e use M P efor efere I er ad b for futur Re tain & re AT I O RM N For all customer enquiries or for replacement parts, contact:- 01325 300303 www. eletrolux. com/mcculloch eop. customer. services@electrolux. co. uk 1 Carton Contents adjustable handle trigger 2 handle knobs mode indicator 2 handle bolts Air inlets debris bag frame adjustable shoulder harness debris bag cutting lines instruction manual nozzle IMPORTANT !Please check the contents of the carton are correct BEFORE assembling your new Flymo product. IF ANY PARTS ARE MISSING CONTACT:- Electrolux Outdoor Products Customer Service Department direct Telephone : 01325 300303, Fax : 01325 318193 Safety If not used properly this Gardenvac can be dangerous. The warnings and safety instructions must be followed to ensure reasonable safety and efficiency in using this product. [. . . ] Place the cutting line into the slot in the cutting head and click into place as illustrated in Figure D. · Ensure the cutting line is correctly located. · ONLY USE CUTTING LINE SPECIFIED FOR THIS PRODUCT. SEE PRODUCT RATING LABEL FOR MODEL DETAILS E 1 4 2 To Fit Assembled Debris Bag To Product (E) · · Switch off and disconnect from the mains electricity supply BEFORE REMOVING OR REPLACING the fully assembled debris bag. The cutting head and cutting line continue to rotate after your Gardenvac has been switched off. IMPORTANT: Do not squeeze the trigger when fitting the debris bag (E1) 1. Ensure debris fin is horizontal (E2) as illustrated in fig E. Locate bag frame into clip on the underside of product. Lift handle towards product until bag latch locates and click into place. (E4) 3 1 debris fin 2 4 Assembly instructions F To 1. 3. Remove Debris Bag From Product (F) Gently press bag latch (F1) down. Lower handle of bag frame away from product. Move bag frame forward. 1 G Fitting the Handle Bolt (G) 1. Place handle bolt into the location slot on the product and slide into place. (G). Repeat on the other side. Fitting the Handle (H) 1. Locate handle onto handle bolts on each side of the product. Secure handle by turning handle knobs clockwise. The handle can be adjusted by turning handle knobs 3 full turns anti-clockwise, moving handle to position required and re-securing handle as described in 2. H J Buckle Fitting The Shoulder Harness (J) & (K). Thread strap through the slots in the handle. (J) 2. Adjust as required to ensure the shoulder harness is in the most comfortable position. K. K 5 How to Use WARNING The use of eye protection is recommended. The use of ear protection is recommended. To prevent dust irritation, the wearing of a face-mask is recommended. [. . . ] Electrolux Outdoor Products does not accept liability under the warranty for defects caused in whole or part, directly or indirectly by the fitting of replacement parts or additional parts that are not either manufactured or approved by Electrolux Outdoor Products, or by the machine having been modified in any way EC Declaration of Conformity I, the undersigned M. Bowden of Electrolux Outdoor Products, Aycliffe Industrial Park, NEWTON AYCLIFFE, Co. Certify that the product:Category. . . . . . . . Electrolux Outdoor Products Conforms to the specifications of Directive 2000/14/EEC I, the undersigned M. [. . . ]