User manual MCCULLOCH CABRIO 262

[. . . ] GB DE FR NL NO Electrolux Outdoor Products Via Como 72 23868 Valmadrera (Lecco) ITALIA Phone +39 0341 203111 - Fax +39 0341 581671 www. electrolux. com Our policy of continuous improvement means that the specification of products may be altered from time to time without prior notice. Electrolux Outdoor Products manufacture products for a number of well known brands under various registered patents, designs and trademarks in several countries. Electrolux Outdoor Products Italy INSTRUCTION MANUAL IMPORTANT INFORMATION: Please read these instructions carefully and make sure you understand them before using this unit. Retain these instructions for future reference. [. . . ] Open the cap on the tank carefully to eliminate any excess pressure. Do not take the cap off the tank with the engine running. Fill the tank in a well-ventilated place. Place the machine on a solid flat surface so that it cannot tip over, with the cap on the tank facing upward. Clean the area around the fuel cap before removing it, to prevent any impurities from contaminating the fuel. Take the cap off the fuel container carefully. Unscrew the cap on the fuel tank and fill it with the necessary quality, using a funnel. After filling the tank, screw the cap on tightly. During use, to prevent problems in starting the engine again, we strongly recommend that you avoid letting the fuel run out in the tank. If you spill any fuel, wipe it off the machine. If you have spilt it on yourself, change your clothes at once. The muffler gets very hot during use and remains hot for some time after switching off the engine. Take every precaution to reduce the fire hazard, especially in the presence of inflammable materials or gas. Fuel storage Gasoline is highly inflammable. Before going near any type of fuel, put out your cigarette, pipe or cigar. Store the fuel in a cool, well-ventilated place, in an approved fuel storage container. Never store the engine with fuel in the tank in a poorly ventilated place where the fumes produced by the gasoline could propagate and reach a fire, candle, burner or furnace pilot light, water heater, dryer, etc. The fumes produced by the fuel can cause an explosion or fire. Never store excessive quantities of fuel. ENGLISH - 5 E. Assembly of safety guard Fit the safety guard (A) against the gearbox (I) position the lower clamp (G) in the housing under the shield and the upper clamp (F) over the shaft. Safety guard extension (exclusively for use with nylon string head) The extension (B) should be installed only for use with the nylon string head, with the aid of the string cutter blade (L), that regulates the length of the string and thus the cutting diameter. For correct assembly see the illustration on the cover and perform the following sequence of steps: Insert the extension (B) on the safety guard (A) at the reference notches (C), and fasten with the screws (D), then apply the string cutter blade (L) with the cutting edge facing towards the outside of the shield, and fasten it with the screw (E) (Make sure the screws are tightened all the way (E) and are not loosened by the vibrations. [. . . ] The machine is ideal to complete the work of the lawnmover. In fact, it can reach places where a normal lawnmower is unable to go. During the cutting operations, keep the engine running at high speed. After every cutting stage, decelerate the must be made without using the blade. [. . . ]