User manual MCINTOSH MVP871

[. . . ] Audio Video Player Manufactured under license from Dolby Laboratories. "Dolby", "MLP Lossless" and the double-D symbol are trademarks of Dolby Laboratories. HDMI, the HDMI long and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC. This product incorporates copyright protection technology that is protected by U. S. [. . . ] Refer to figure 32. Note: The title of the icon button-bar will change color from yellow (the cursor color) to blue indicating the selected item. 4. Return to the Video Setup Menu by pressing the Left followed by the Up directional Push-buttons. Next continue to the SQUEEZE MODE Settings. If no other changes are to be made in Setup Mode at this time, exit by pressing the RTRN (Return) Push-button. Squeeze Mode When the MVP871 is connected to a TV/Monitor with either a Component Video or HDMI connection and the TV Aspect Ratio is set to 16:9 and a video source with an Aspect Radio of 4:3 is displayed, the image will be stretched out. The Squeeze Mode will compensate by displaying the 4:3 image in the center of the screen. The default setting is Off with additional choices of On or Auto. To change from the default setting perform the following steps: 1. Press the SETUP Push-button on the supplied Remote Control to access the Language Setup Menu. Then press the Right directional Push-button to select the Video Menu Icon Tab. Refer to figure 24. Note: If there is a Disc playing in the MVP871 press the STOP Push-button twice before pressing the SETUP Push-button. Note: The SETUP Push-button may also be pressed to exit the setup mode. 2. Use the Down directional Push-button on the Remote Control to select the AUDIO/VIDEO SYNC Menu. To change from the default setting use the Right directional Push-butFigure 31 ton followed by 28 2. Use the Down directional Push-button on the Remote Control to select the SQUEEZE MODE Menu. To change from the default setting use the Right directional Push-button followed by Up or Down directional Push-buttons and then press the SELECT Push-button. SETUP, con't 4. Return to the Video Setup Menu by pressing the Left followed by the Up directional Push-buttons. Next continue to the PROGRESSIVE MODE Settings. If no other changes are to be made in Setup Mode at this time, exit by pressing the RTRN (Return) Pushbutton. Progressive Mode When the Component Video Output (Analog Video) is connected to the TV/Monitor and the Progessive Mode is set to Auto (default setting) the MVP871 will produce the best possible picture quality. The two additional Modes of Progressive Scan "Video1" and "Video2" allow for manual override when the Progressive Scan Circuits can not detemine whether the video signal is film or video based. Video1 setting will look best with Video Source material and Video2 will look best with Film Source material. [. . . ] Press the Right directional Push-button to select the Image's Vertical Position on the screen. Use the Up directional Push-button to shift the image up or use Down directional Push-buttons to shift the image down, range of adjustment is -7 to +7. Note: The Vertical Position adjustment is active for the Component Video Outputs with the Progressive Scan Mode active and HDMI Outputs. Note: The Horizontal Position adjustment is active for the Component Video Outputs with the Progressive Scan Mode active and HDMI Outputs. used sparingly, they can make a significant improvement in the appearences of the video image, over use can also have the opFigure 89 posite effect. Press the SELECT Push-button to select the OnScreen Gamma Graph. Use the Right or Left directional Push-buttons to highlight the desired adjustment point on the Gamma Curve. [. . . ]