User manual MCINTOSH MX130

[. . . ] MX130 A/V TUNER CONTROL CENTER MX130 A/V TUNER CONTROL CENTER IMPORTANT SAFETY INSTRUCTIONS THESE INSTRUCTIONS ARE TO PROTECT YOU AND THE MclNTOSH 1. 4. Read all instructions - Read the safety and operating instructions before operating the instrument. Retain Instructions - Retain the safety and operating instructions for future reference. Heed warnings - Adhere to warnings and operating instructions. [. . . ] In Area "B", pressing POWER turns on only Area "B" after the SYS OFF is activated. Press POWER to turn on the main system in Area "A". Press in Area "B" to turn on just Area "B" Outputs and dedicated power amplifier. Each time Area "B" is turned on, TUNER is automatically selected at a volume level 50dB below maximum. The Area "A" power amplifier and dedicated Area "B" power amplifier AC power cords must be connected to or controlled by their respective MX130 rear panel Area "A" and Area "B" AC outlets. Select Tuner functions of AM, FM, SEEK UP ( ) or SEEK DOWN ( ). When an RCT-1 Translator is being used to control a TV set, the SEEK UP or DOWN pushbuttons can be used to change TV channels. First press TUNER and then press REVIEW to start the automatic 3 second audition of each of the preset stations stored in tuner memory. Press REVIEW again to stop on the desired preset. Cancel the REVIEW process by pressing REVIEW a second time, or pressing any other Tuner function pushbutton. E, (ENTER or EXTRA) is used for controlling functions of an accessory component when an RCT-1 Remote Control Translator is being used. 16 10. Press MUTE to mute the audio signals separately in either Area "A" or "B". Area "A" muting is indicated by the front panel LED above the VOLUME control blinking on and oft. To unmute Area "A", press MUTE a second time, press an UP ( ) or DOWN ( ) VOLUME pushbutton or turn the front panel VOLUME control. Area "B" muting is indicated by the LED in a wall sensor or keypad blinking on and off. To unmute Area "B", press MUTE again or press an UP ( ] or DOWN ( ) VOLUME pushbutton. SP (Surround Processor) pushbutton switches Area "A" surround signal processing functions IN or OUT in HALL, CINEMA 1 or CINEMA 2 modes. When signal processing is switched OUT, the MX130 returns to normal STEREO operating mode. An LED above the front panel SURR PROC pushbutton turns on to indicate when signal processing is active. Press either the UP ( ) or DOWN ( ) SURROUND pushbutton to calibrate individual channel level balance during surround sound calibration procedure on all six channels. You can also raise or lower the surround sound levels during normal operation with these pushbuttons. Press UP VOLUME ( ) to raise the listening volume and DOWN VOLUME ( ) to lower the listening volume. [. . . ] LEFT and RIGHT SURROUND channels, 0. 1% from 125Hz to 7000Hz. SENSITIVITY PHONO: 5. 0mV for 2. 5V output, (1. 0mV IHF) HIGH LEVEL: 500mV for 2. 5V output, (100mV IHF) DOLBY LEVEL: 200mV input. SIGNAL-TO-NOISE RATIO, A-WEIGHTED MONO, STEREO and HALL MODES LEFT, CENTER and RIGHT FRONT Channels. PHONO: 90dB below 10mV input, (84dB IHF). [. . . ]