User manual MEDION 8 IN 1 UNIVERSAL REMOTE CONTROL MD 81035

[. . . ] Before using the remote control for the first time, please read these instruction carefully. Keep the in structions in a safe place for reviewing purposes or for passing them on to third parties. Do not examine the laser with optical instruments!Do not subject your remote control to dust, strong sun light, moisture, high temperatures or strong vibrations. [. . . ] This acts as a protection from accidental recordings. Several controlling options are available to combined de vices. TV set with video recorder) require two device codes one for each device part. The combined device is then controlled like two separate de vices. Other combined devices only require one code. In this case, you must first select the device part you would like to ope rate. Now activate the DVD part in the combined device by hol ding down the DVD source key for longer than one se cond. To activate the video recorder in the combined device, first briefly press the SETUP key, then the DVD source key. If your combined unit only requires one code but you would like to operate it with two source keys, then proceed as fol lows: Programme the device code to two source keys. Operate one of the unit parts with one of the two source keys. Use the learn function (see next chapter) to transfer the desired functions of the other unit part to the other source key. You can manually save the functions of an original remote control to your universal remote control. Use new batteries for both remote controls. One original remote control can be saved to every source key (8 in 1 function). Once the memory is full, the background lighting of the source key will flash for 3 seconds. If you are programming an additional function to an exi sting code, please take note which keys are still unassi gned beforehand. The following keys cannot be assigned to functions: LEARN, SETUP, ALL OFF, MACRO and all source keys. Some original remote controls (for DVD, video recorder, SAT) can themselves be programmed with the device co des of some TV brands to carry out basic TV set functions (volume, mute, channel search). Do not attempt to transfer the functions of an original re mote control that has been programmed with the code of a different TV set to your universal remote control. First try to program any type of command and then test it. Then delete all commands (see "Deleting commands for all source keys" on page 9) and begin with the actual pro gramming. Do not execute the learn function under a low energy lamp. [. . . ] Press the key until the source key light extinguishes briefly. Press the source key for the device that is only to have its own volume and mute functions. The light of the source key remains lit. Press the key again, and the source key light will extinguish. [. . . ]