User manual MEDION MD 20081 CODE LIST

[. . . ] We have structured these instructions so that you will be able to read the information needed subject-related at any time. Keep the instructions safe, in order for you to be able to pass them on to a new owner, in the case of you selling the monitor. These instructions are intended for both first times users and those with previous experience. We have selected the components that make up this product with an attention to functionality, ease of operation, safety and reliability. [. . . ] Now connect one end of the mains cable supplied with the device to TFT power supply connection and then the other end to an appropriate socket. The mains socket must be in the vicinity of the TFT monitor and be easily accessible (use the same electricity circuit as for the PC). Switch your monitor on at the Standby/On switch on the front of the device. Bringing the device into operation Please pay attention to the following: The monitor device should be set up so that mirror effects, fading and strong contrasts between light and dark are avoided (even if the view from the window is still so attractive!Surface supporting the hands: 5 - 10 cm Highest monitor line at eye level or somewhat below it Viewing distance: 40 to 70 cm Leg-room (vertical): At least 65 cm Leg-room (horizontal): At least 60 cm Press this button again if you wish to leave the OSD. + + Power block, when the OSD is not activated OSD block, when the OSD is not activated Hold the key combination until the bar displayed has moved from left to right completely, to activate/de-activate the block. a corresponding message will appear on the screen. Select a parameter and reduce its value with this button, when the OSD is switched on. If you are not in the OSD: direct call-up of the Contrast/Brightness menu. Select a parameter and increase its value with this button, when the OSD is switched on. When the OSD is not active: direct access to the aspect ratio menu. Signal input: Please check whether the signal input (computer or other device) is switched on and the connection cables are sitting firmly in the sockets. What software were you using when the fault arose?What steps have you already taken to solve the problem?Give us your customer number if you have already received one. You will be able to extend the useful life of the TFT monitor by the following measures: Attention!No parts to be maintained or cleaned are located within the monitor casing. Always pull out the mains plug and all connecting cables before cleaning. Do not use any solvents, corrosive or gaseous cleaning substances . Clean the screen with a soft, fluff-free cloth. Pay attention that no drops of water remain on the TFT monitor. Do not subject the screen to either dazzling sunlight or to ultra-violet radiation. [. . . ] In direct sunlight or in a damp room); accidental damage; use other than in accordance with the accompanying user or instruction manual; modifications, conversions, expansions, maintenance and/or repairs made to the MEDION product by unauthorised repairers or use of unauthorised third party parts; negligence; virus attack or software errors; or improper transportation or packaging during return of the product. This warranty will also be considered void if labels or serial numbers of the product or of a component of the product are modified or made illegible. To the extent permitted by law, MEDION shall; only be responsible for losses which are a reasonably foreseeable consequence of the relevant defect in the product; MEDION will not be responsible for any costs incurred in relation to software configuration; economic loss; loss of opportunity; loss of income; or loss of data or software arising out of its repair or replacement of a MEDION product under this warranty Before returning the product to MEDION you must contact us using the service hotline or via the internet (www. You will receive further instructions for making your claim under warranty when you call. [. . . ]