User manual MEDION MD 82467 CODE LIST

[. . . ] 26 Deleting commands for only one mode key . Please read these instructions carefully before operating the remote control. Keep the instructions in a safe place for future reference or in case you need to pass them on to someone else. The device has a safety system that prevents the emission of dangerous laser rays escaping from the device during normal use. [. . . ] If you miss the code, you can go back step by step with the P­ key. When the device responds accordingly each time a key is pressed, press OK to save the code. If you want to know which code is saved on a particular mode key, simply press this key. After you have finished programming your remote control for your audio/video devices, the remote control will work in the common main functions just like the original remote control for the respective device. point your remote control at the desired device and press the relevant mode key. The mode key label is displayed with the programmed in code. [For the universal functions ­ see Universal functions ("Punch Through") on page 29 ­ you do not need to press the mode key in advance. ] Activate the functions by pressing the corresponding function key on your universal remote control. The symbol for infrared transmission appears each time you press a key. Each time a key is pressed the display backlight switches on for between 10 and 60 seconds (to set this duration please read: "Backlight" on page 10). Please note: In certain circumstances, not every function of your original remote control may be directly available on the universal remote control. Especially for newer devices, it might be possible that the functions are stored to different keys than expected or may not even be available at all. In these cases you can use the learn function to transfer the functions of your original remote control to the desired keys of the universal remote control (see "Learn function" on page 24). After you program a device code, the universal remote control keys can have double functions (with the exception of the SETUP and MACRO keys). To use the second function, briefly press the SETUP key and then (within 15-20 seconds) press one of the secondary function or number keys. Try out which additional functions a key has for a particular device code. To enter the time after Use the arrows which the TV device should switch itself off automatically. press OK" The SUCCESS confirmation message appears along with the TV timer symbol "Zzz". Lay the universal remote control down so that it is pointing towards the device and is not obstructed. If a sleep-timer is on ("Zzz" appears in the display) TV SLEEP CLEAR appears in the display instead of TV SLEEP SET when you perform the steps described above. Switching to another programme); the bell symbol appears in the display. You can use the command timer to program a function that is to run automatically at a particular time within the next 24 hours. [. . . ] PLEASE WAIT appears again in the display, followed by the confirmation message SUCCESS. If you selected the wrong device that does not have its own volume control, an error message appears. You can program the universal remote control in such a way that it will use only that particular device's own VOL/MUTE functions. The "Punch Through" function for this device is therefore switched off. [. . . ]