User manual MEDION MD 85903 CODE LIST

[. . . ] Contents About these instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Operating safety. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Package contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Overview of the appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Do not scan high gloss photos in an environment of more than 70% atmospheric moisture. The surface could adhere and cause a paper blockage. 12 Photographic protective foil Photos may be damaged by minute dust and dirt particles (fine traces of scratching appear) during the scanning process. This is particularly possible in the case of high gloss photos. For this reason we recommend that you scan all photos in the protective foil supplied with this appliance. Automatic image trimming The scanner needs a narrow edge to establish the image data. This edge may be trimmed off during scanning in the following way: Scanning direction Scanned image Please take account of this: the darker the image, particularly at the edge, the more will be trimmed off. 13 Colour correction (brightness and colour tone) The colour will be corrected automatically during scanning. The brightness and colour tone can differ from the original to some extent. The result of this colour correction can also depend on the direction in which the image has been scanned. Different results are not an error by the appliance. Attempt to scan the image in a different direction if the edge has been trimmed off to wide. 14 About memory cards Use unlocked, readable memory cards with at least 1 MB free memory. The FAT (FAT16) and FAT32 formats are supported, not NTFS or a different format. The following storage media are possible: CF (Compact Flash- card) Typ 1 MS ("Memory Stick"); MS Pro; MMC (Multimedia- Card); SD ("Secure Digital"). Storage priority Scanned images will be stored in the following priority, if several memory cards have been inserted: SD (MMC) > CF > MS. 15 Operation First operation Remove all foil from the device before bringing it into operation for the first time. Scanning a photo Proceed as follows: Connect the mains cable. Install the software as described on page 18, to operate the device without a memory card. Insert a memory card: Push in an SD or MMC card with the contacts downwards and the chamfered corner facing to the right. Push in a compact flash card (CF card) with the front side facing forwards. Pay attention to the fine pins in the appliance in the case of CF cards. They must not be damaged! 16 Push the photo to be scanned under the protective foil so that it is lying firmly between the two black position marks at the front. Press the operating button. The operating display will flash quickly. Wait until the operating display has stopped flashing and the status display is shining continuously instead. Place the photo into the protective foil at the left edge of the intake slot with the image facing upwards. The black edge of the protective foil will lie in front. Push the paper guide to the right edge of the photo. The photo will be pulled through ­ do not pull on the photo! [. . . ] The card must be inserted in the direction shown. The calibration will not function otherwise. 28 Storage Keep the appliance and the cleaning set (roller cleaning sheet, sensor wiper, calibration card) in its packaging in a cool, dry, dust-free location. 29 In the case of faults Problem The scanned images show lines or stripes, or are less clear than the original. The original is stuck firmly in the intake. The photo is not being scanned and the status display is flashing quickly. [. . . ]