User manual MEDION PNA 205

[. . . ] Contents Safety and Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Safety Instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Data Security . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Operating Environment. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Repair. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Should this not be possible, then mount the holder with the suction plate in any way that will allow peril-free and safe operation. Snap-in lever Suction plate (optional) (similar picture) Note If you want to fix the holder to the wind screen, then you can skip steps 1 and 2. Note 26 English Your navigation system can also be equipped alternatively with another car mounting according to the version. Remove the protective foil from the sticky side of the suction plate. Fix the suction plate to a suitable location on the dashboard. Take care, that the surface of the dashboard is clean and press the suction plate strongly onto the surface. Note To obtain a strong and secure hold the suction plate should not be used for 24 hours. Note It cannot be excluded completely that certain plastics, strong solar radiation, etc. will affect or soften the adhesive strips and will be able to damage the surface of the dashboard through this. We shall not accept any liability for damage to the dashboard that may occur. Pay attention to the inscription on the car mounting. The connection closes with a noticeable clicking sound (fig. Fixing the Suction Plate Note Clean the disk thoroughly with a glass cleaner. Warm the disk and the nipple slightly at temperatures below 15° C. Place the holder with the suction head onto the suction plate (or directly onto the wind screen) and press the lever on the suction head downwards. The sucker will attach itself to the background firmly. Navigation 27 III. Connect the car adapter (see page 16) and, if necessary, the external GPS aerial, to your navigation system and insert the memory card. Place the holder on to the fixing holes and slide the holder to the left, until it engages audibly. Attach the device to the holder by placing it below the holder and pressing it upwards, until it engages audibly. Now you will be able to place the complete unit on the cleaned windscreen or the suction plate. holder cradle (similar picture) 28 English IV. Connecting the Car Adapter (similar picture) 3. Plug the jack ( ) of the connection cable into the corresponding receptor at the bottom of your navigation system (p. Insert the power adapter ( ) now into the cigarette lighter socket and ensure, that it will not lose contact while driving. [. . . ] 18 Installing the navigation software . . . . . . . . . . . . . . . . . . . . . . . 16 Switching on the navigation system . . . . . . . . . . 19 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . 9 L Left Components. . . . . . . . . . . . . . . . . . 14 Liability limitations . . . . . . . . . . . . . . . [. . . ]