User manual MEDION TFT DISPLAY MD 40830

[. . . ] Wear protective gloves to pack the broken parts and send them into your service center for proper disposal. Then wash your hands with soap, because it is possible for chemicals to escape. Do not touch the display with your fingers or with sharp objects to avoid damage. After transporting your TFT monitor please wait until it has assumed the ambient temperature before connecting and switching it on. [. . . ] After transporting your TFT monitor please wait until it has assumed the ambient temperature before connecting and switching it on. Extremely high variations in the temperature or humidity may result in condensation forming on the inside of the TFT monitor which could cause an electrical short-circuit. This monitor compiles with the regulation ISO 13406-2 class II (Class of pixel failures). If you have previously used your computer with a CRT monitor, you will need to make sure that your computer's display settings are supported by your TFT monitor. The following pages describe how to verify and change your display settings. Ensure that the TFT monitor is not yet plugged in and neither the TFT monitor nor the computer is switched on. Prepare your computer for the TFT monitor if necessary with the correct settings for your TFT. If your display settings exceed the capabilities of your monitor, your monitor may show only a blank display. Operate your TFT monitor only with grounded outlets with AC 100-240V~/ 50-60 Hz. If you are not sure about the power supply at your location, check with your power company. With this key you can automatically adjust the image. Blue = Normal mode, Orange = Stand-by mode With this switch you can switch the LCD monitor ON and OFF. It can be difficult to check some of the settings listed below if your display is blank!In order to get an image on your screen so that you can check the settings, it may be necessary to start your computer in safe mode. When starting your computer, press F8 before the Windows logo screen appears. Windows NT 4 When starting your computer, select the boot option with [VGA Mode] at the end. Windows 2000/XP When starting your computer, press F8 before the Windows logo screen appears. It may be necessary to reinstall your video driver while in one of these modes in order to reset the resolution and refresh rate. Press any desired key and move the mouse to deactivate the mode. If pins are bent, please contact your call center. [. . . ] Press any desired key and move the mouse to deactivate the mode. If pins are bent, please contact your call center. set the appropriate values for your TFT monitor. Picture runs or is not stable: Signal cable pins. [. . . ]