User manual MEDION UNIVERSAL REMOTE CONTROL CODELIST

[. . . ] 13 13 14 14 14 15 16 17 18 Normal operation . 19 EPG ­ Electronic Programme Guide . 24 24 25 26 3 Univ-FB_MD 81302_UK. fm Seite 4 Montag, 7. . 27 27 28 29 Universal functions ("Punch Through") . [. . . ] The mode key label is displayed with the programmed in code. [For the universal functions ­ see "Universal functions ("Punch Through")" on page 30 ­ you do not need to press the mode key in advance. ] Activate the functions by pressing the corresponding function key on your universal remote control. The symbol for infrared transmission appears each time you press a key. Each time a key is pressed the display backlight switches on for between 10 and 60 seconds (to set this duration please read: "Backlight" on page 11). Please note: - In certain circumstances, not every function of your original remote control may be directly available on the universal remote control. - Especially for newer devices, it might be possible that the functions are stored to different keys than expected or may not even be available at all. In these cases you can use the learn function to transfer the functions of your original remote control to the desired keys of the universal remote control (see "Learn function" on page 24). SHIFT function After you program a device code, the universal remote control keys can have double functions (with the exception of the S_(Setup) and MACRO keys). To use the second function, briefly press the S (SETUP) key and then (within 15-20 seconds) press one of the secondary function or number keys. Try out which additional functions a key has for a particular device code. Recordings The (Record) key for recording (e. g. on video recorder, DVD, or cassette recorder) must be pressed twice. This acts as a protection from accidental recordings. EPG ­ Electronic Programme Guide The EPG ("Electronic Programme Guide") key has various functions depending on which code has been used: For TV and satellite codes (e. g. Press S briefly twice more to open TIMER SETUP. Press OK" The TV SLEEP SETUP menu is displayed. Press OK" The TV SLEEP SET display appears. Press OK" The number of minutes flash in the display. Use the arrows to enter the time after which the TV device should switch itself off automatically. 7. Press OK" The SUCCESS confirmation message appears along with the TV timer symbol "Zzz". Lay the universal remote control down so that it is pointing towards the device and is not obstructed. Switch off sleep-timer If a sleep-timer is on ("Zzz" appears in the display) TV SLEEP CLEAR appears in the display instead of TV SLEEP SET when you perform the steps described above. Perform steps 1 to 4 as described above. Press OK" The message CONFIRM CLEAR is displayed. Press OK" The SUCCESS confirmation message appears. 21 Univ-FB_MD 81302_UK. fm Seite 22 Montag, 7. August 2006 11:08 11 Command timer The clock must be set for this timer. [. . . ] PLEASE WAIT appears again in the display, followed by the confirmation message SUCCESS. If you selected the wrong device that does not have its own volume control, an error message appears. Switching off the VOL/MUTE universal function for a specific device You can program the universal remote control in such a way that it will use only that particular device's own VOL/MUTE functions. The "Punch Through" function for this device is therefore switched off. The universal function cannot be switched off for the TV mode. As described in the previous section, if you have selected a different mode for the VOL/MUTE universal function, you will not be able to switch off the universal function for this mode either. [. . . ]