User manual MEDION UNIVERSAL REMOTE CONTROL MD 41666

[. . . ] OVERVIEW OF THE KEYS 1 TABLE OF CONTENTS General . Universal functions ("Punch Through"). 17 2 GENERAL Safety instructions Do not try to repair the remote control yourself. The universal remote control is equipped with a class 1M infrared diode. [. . . ] Enter the applicable one-digit code from the table below: key 1 = Medion, Tchibo key 2 = Philips, Radiola, Philco, Erres, Pye key 3 = Sony, Akai, Panasonic, JVC, Sharp, Toshiba, Daewo key 4 = Thomson, Brandt, Fergusson key 5 = Saba, Nordmende, Telefunken key 6 = Grundig, Blaupunkt key 0 = all brands. Press the CHAN+ key (or, in case of video cassette recorders, POWER or PLAY) until the device responds correctly. Proceed swiftly when doing this, otherwise the automatic code search will be started. Store the code by pressing the "OK" key. If all codes have been searched, the MODE key will blink for about 3 seconds. 8 Code identification The code identification allows you to identify codes that you have already entered and that are memorised in the remote control. 3 seconds until the backlight illumination of the MODE keys flashes shortly and then lights up steadily. (By briefly pressing the "SETUP" key, you activated the SHIFT function) 2. Briefly press the key for the desired mode (TV, VCR, SAT). Each time you press a key, the MODE key illumination will briefly go out. Each time you press a key, the MODE key illumination will briefly go out. To find the first numeral, press the numerical keys from 0 to 9. When the MODE key illumination goes briefly out, this is the memorised numeral. To determine the second and the third number, repeat the procedure. The MODE key will go out as soon as the key for the third number has been pressed. The code identification has now been completed. 9 LEARN FUNCTION The universal remote control provides you with the possibility of manually storing certain special functions which have not been stored, or even devices which have not been included in the code list. To do this, the original remote control of your device is required in any case. However, please note the following tips beforehand in order to avoid any mistakes. · Use new batteries for both remote controls. · You can assign one remote control to each of the MODE keys. · Place the remote controls with the infrared diodes on a table so that they point each other at a distance between 15 and 50 mm. · You can store up to 150 commands. When the memory is full, the backlight illumination of the MODE key will be flashing for 3 seconds. · Each programming of a key can take approx. [. . . ] Some devices can be switched on and off by means of the POWER key. Such switched off devices will be switched on after completion of the ALL OFF function. Autozapping In case of TV operation, you will successively go through all stored channels by once pressing the SHOWVIEW key (to that end, the remote control has to be pointed permanently at the device). Press the CHAN key once to finish the function. [. . . ]