User manual MEDION UNIVERSAL REMOTE CONTROL MD 4688

[. . . ] If code set-up was successful the mode LED turns off after having entered the last number. (If the code was incorrect the mode LED will blink 3 seconds before it goes out. ) 6. The direct code entry is complete now. If the device does not respond correctly, please repeat the setting up by trying the next code from the code list for your device until the equipment works properly. If none of the listed codes work, go to Chapter SETTING UP BY MANUAL SEARCH. 4 SETTING UP BY MANUAL SEARCH If the device does not respond to your remote control, although you tried all codes from the code list for your device, use the manual code search. [. . . ] The remote control transmits the codes successively (Interval 1 sec). If the device doesn't have a channel function press instead of "PROG+" the "PLAY" or "POWER" button. When the device reacts to the remote control press "OK". If you missed to press "OK" in the right moment you can go back step by step to the right code by pressing "PROG-" Note: If you wish a larger transmitting interval (3 sec instead of 1 sec) press the "PROG+" ("PLAY", "POWER") button twice in step 5. 6 CODE SEARCHING BY BRAND NAME This function makes it possible to search the code by the respective brand name. Find the names enclosed in the code table. Do as follows: Switch on the device you want to operate. Press and hold "SETUP" for 3 seconds. (If you press the "SETUP" button only once you activate the SHIFT- function). Shortly press the button for the mode you want to operate (TV, VCR, SAT). Enter the 1-digit-code from the code table. Press the button "POWER" or "PROG+" or "PLAY" several times until the device works as desired. Store the code by pressing "OK". Did you run through all codes the mode LED blinks for about 3 seconds. CODE IDENTIFICATION This code identification gives you the possibility to select the stored codes directly with the remote control. Press and hold "SETUP" for 3 seconds. (If you press the "SETUP" button only once you activate the SHIFT- function). Shortly press the button for the mode you want to operate (TV, VCR, SAT). If the operating modus is accepted the mode LED goes out for a moment. Shortly press the "SETUP" button. If the operating modus is accepted the mode LED goes out for an instant. To find the first number press the numbered buttons shortly one after the other. If the code number is correct the mode LED goes out for a moment. For the second and third number use the same procedure. [. . . ] Switch on the device you want to operate (TV, VCR, etc. ) 2. Press and hold "SETUP" button for 3 seconds. The LED will light up continually after blinking . Press once the "P<P" button. [. . . ]