User manual MEDION UNIVERSAL REMOTE CONTROL MD 80383 CODELIST

[. . . ] Do not look at the laser using optical instruments!Do not expose your remote control to dust, intense sunlight, humidity, high temperatures or mechanical shocks. Old and new batteries must never be combined. Do not use any corrosive or aggressive cleansing agents. [. . . ] Point the remote control at the device and press the CHAN+ key once briefly. If the device does not possess a channel function, then press the PLAY or POWER key instead of CHAN+. After 6 seconds, the remote control will start the code search and successively send all codes at one second intervals (also see the next section). When sending, the MODE key will light up each time. As soon as the device does respond to the remote control, press the OK key. ­ Should you fail to press the OK key in time, you can step by step return to the code to which the device has responded using the CHAN- key. 1-second or 3-second intervals If you want the remote control only to send a new code every 3 seconds instead of every second, proceed as follows: After you have pressed the CHAN+ (or PLAY or POWER) key as described in section 5, press the CHAN+ key (search forwards) or CHAN(search backwards) another time within 6 seconds. Now, the remote control will send new codes only at intervals of 3 seconds. This will give you more time, but the procedure will also take longer. 7 Code search by brand This function provides you with the possibility of searching by brands. You will find the brands in the code table under "Code search by brands". Switch on the respective device manually. · Place the remote controls with the infrared diodes on a table so that they point each other at a distance between 15 and 50 mm. · You can store up to 150 commands. When the memory is full, the backlight illumination of the MODE key will be flashing for 3 seconds. · Each programming of a key can take approx. · If you want to programme an additional function to an existing code, verify in advance which key has not yet been allocated and is still free for programming. · The following keys cannot be programmed with functions: LEARN, SETUP, ALL OFF, MACRO, SHOWVIEW and all MODE keys. · First have a try by programming any desired code and testing it then. Thereafter, delete all codes and proceed with the proper programming. Do not use the learn function beneath an energy saving lamp. 10 Programming functions Programming is carried out as follows: 1. 3 seconds until the backlight illumination of the MODE keys flashes shortly and then lights up steadily. (By briefly pressing the "SETUP" key, you activated the SHIFT function) 2. Briefly press the desired MODE key (TV, VCR, DVD, SAT, DSAT, CD, CBL, AUX). [. . . ] Press the ALL OFF key immediately once again and keep it pressed for approx. Now, all pre-programmed devices are switched off one after another. Then, the MODE key illumination will go out. The remote control has to be pointed at the devices to be operated until the MODE key goes out. [. . . ]