User manual MEDION UNIVERSAL REMOTE CONTROL MD 81302

[. . . ] Univ-FB_MD 81302_UK. fm Seite 3 Montag, 7. August 2006 11:08 11 Contents Safety instructions . Protection against unexpected battery discharging 6 6 6 6 The display . Entering the device code according to the code list . [. . . ] Try out which additional functions a key has for a particular device code. Recordings The (Record) key for recording (e. g. on video recorder, DVD, or cassette recorder) must be pressed twice. This acts as a protection from accidental recordings. EPG ­ Electronic Programme Guide The EPG ("Electronic Programme Guide") key has various functions depending on which code has been used: For TV and satellite codes (e. g. SAT-TV or DVB-T), the button opens the electronic programme guide. For DVD codes the button opens the title menu. 19 Univ-FB_MD 81302_UK. fm Seite 20 Montag, 7. August 2006 11:08 11 For VCR codes you can use the button for programming, if your video recorder has a Showview function. If the device has both an EPG and a Showview function, the EPG function is given priority. Operating combined devices Combined devices are for example a TV set with an integrated video recorder, a TV set with a DVD player or a DVD recorder with a video recorder. Several controlling options are available to combined devices. Combined devices with two device codes Some combined devices (e. g. TV set with video recorder) require two device codes - one for each device part. Program the correct TV code on the TV mode key and the video recorder code on the other mode key. The combined device is then controlled like two separate devices. Combined devices with one device code Other combined devices only require one code. In this case, you must first select the device part you would like to operate. Example: The device is a combined DVD recorder/video recorder. The device code was stored on the DVD mode key. Now activate the DVD part in the combined device by holding down the DVD mode key for longer than one second. To activate the video recorder in the combined device, first briefly press the S (Setup) key for the SHIFT function, then the DVD mode key. If your combined unit only requires one code but you would like to operate it with two mode keys, then proceed as follows: Programme the device code to two mode keys. Operate one of the unit parts with one of the two mode keys. Use the learn function (see "Learn function" on page 24 ) to transfer the desired functions of the other unit part to the other mode key. ALL OFF function You can switch off all pre-programmed devices at the same time. Press the POWER/ALL OFF key twice in rapid succession and keep it pressed down after the second time for approx. When you release the key, ALL OFF appears and the devices are switched off. Some devices can be switched on and off with the POWER/ ALL OFF key Devices switched off in such a way will, if they were switched off, be switched back on when you perform the ALL OFF function. 20 Univ-FB_MD 81302_UK. fm Seite 21 Montag, 7. [. . . ] Keep the S (Setup) key pressed down for approx. Press S again briefly to open SYSTEM SETUP. 3. Press OK" The VOL/MUTE SETUP is displayed. Use this menu to switch off the VOL/MUTE universal function for an individual device that you can select in the next step. [. . . ]