User manual MEDION WIRELESS RADIO TRANSMITTER SYSTEM MD 81209

[. . . ] ⷠConnect the mains adapters to easily accessible 230V ~ 50Hz power sockets only. Never try to connect the mains adapters to other connectors as this may damage the devices. Remove the mains adapter(s) from the power socket immediately if the mains adapter, the connection cable or the devices are damaged. The low transmitting power of the devices eliminates any danger to health according to the current state of research and technology. [. . . ] ⷠAttach an IR transmitter as described above to each device that you want to use in another location. Connecting more than one device You can also connect a second device to the transmitter that Can send signals from this device to the receiver and control this device remotely from there. You can now use the SOURCE 1/2 switch on the transmitter to choose which signal is transmitted to the TV connected to the AV OUT output. Example of transmitter setup with two devices The following diagram shows a typical arrangement with a satellite receiver, a TV and a DVD player on the transmitter side: Remove the protective cover and insert the mains adapter into the socket (230V ~ 50Hz). Use the channel switch at the bottom of the device to select a channel (A/B/C/D) to which the signal is to be sent. You can also connect the transmitter to a computer in order to transmit computer output to a television, for example. It does not usually make sense to transmit computer output to a TV for running computer applications, since the TV's screen display is not usually good enough to display the higher resolution computer image. If you want to show videos or presentations, however, displaying them via the TV is highly recommended. The operating system and the drivers for your graphics card support video output. As there are numerous combinations of these, we can only provide general instructions here. Please check the operating instructions for your computer or graphics card to see how you can divert the image to video output. The following example requires a PC running the Windows® 98 operating system or above. Close all programs and switch off your computer. ⷠRefer to the operating instructions for your PC and follow the instructions for using video output. If your graphics card does not have a cinch output, use a suitable adapter (optional accessory). ⷠConnect the red and white plugs on the Mini DIN AV cinch cable to the appropriate audio output on your PC. 5mm stereo jacks, so you can use the adapter supplied. Now switch on the transmitting station, the receiving station and your TV, and choose the appropriate video channel on your TV. ⷠStart your PC and wait until the operating system has fully loaded. ⷠRight click once on the Desktop and choose "Properties" to show the "Display Properties": Now click on "Settings" to configure your PC's output. You should therefore check the relevant operating instructions to see how you should proceed. You can usually use the F1 key to call up online help, which provides you with detailed information. [. . . ] Never spray cleaning fluids directly onto the devices. At the end of its life, the radio transmission system should not be disposed of in household rubbish. Seek the advice of your local authority on correct, environmentally friendly disposal. The following overview may help you: No audio/video transmission · Interference can be caused by several factors, such as radio waves from other devices. [. . . ]