User manual MELICONI CONTROL 3-300 PLUS

[. . . ] When the key is released, it will start to flash. Enter the brand code previously identified (e. g. The selection key flashes more quickly to indicate that the remote control is ready for the search. [. . . ] Enter the code 0000; the selection key flashes more quickly to indicate that the remote control is ready for the search. Point the remote control at the appliance. Press and slowly release the ON/OFF key or PLAY for the VCR and DVD several times, stopping when the appliance responds correctly to the command. When the appliance responds correctly, press OK to confirm. Three flashes indicate that the search operation has been completed correctly. or VCR or TER 5 SEC. + + + or ADDITIONAL CHECK Check that some of the other keys, corresponding to those on your original remote control, work correctly. If the commands function incorrectly or erratically, you have probably entered a code for a similar remote control but not the right one. In this case, repeat the search procedure starting from point 2. To display and make a note of the code memorized by means of the search, follow the instructions described in the paragraph CURRENT CODE DISPLAY. NB: THE LIGHT INDICATOR STOPS FLASHING. The remote control exits programming mode and the light indicator stops flashing: · if no keys are pressed for 14 seconds · if a key other than ON/OFF or PLAY is accidentally pressed · if the code search list is completed. In this case consult the enclosed CD or the site www. meliconi. com/guide 8 CURRENT CODE DISPLAY To find out the code of your remote control, follow this procedure: 1. Press the select key for which you want to know the code and hold down for 5 seconds. When the key is released it will start to flash; press and release the 1-/-- key within 8 seconds. After a pause of several seconds, the indicator light produces four series of flashes with a space between them, corresponding to the code you are looking for. Count the number of flashes; each series of flashes corresponds to one figure in the code. Note the code on the adhesive label inside the battery cover in case you have to reprogramme the remote control subsequently. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . = 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . = 6 Code obtained = 1306 or VCR or TER 5 SEC. NB: this operation cannot be interrupted and the remote control cannot therefore be used until the end of the four series of flashes. ENTERING THE CODE If you know the exact code with which to programme the remote control, enter it as follows: 1. Hold down the selection key for the appliance to be programmed for 5 seconds. [. . . ] If required, reset the remote control code, following the programming procedure. The selection keys flash. The batteries are low. Change them. The remote control commands are not all working correcting. You may have used the wrong code. Reset the remote control code, following the programming procedure. [. . . ]