User manual MELICONI GUMBODY UNIVERSAL 3-300

[. . . ] Look in the Code Book for the brand of the appliance to be programmed and make a note of the corresponding code indicated alongside (e. g. Hold down the selection key for the appliance to be programmed for 5 seconds. When the key is released, it will start to flash. Enter the brand code previously identified (e. g. [. . . ] Hold down the selection key for the appliance to be programmed for 5 seconds. When the key is released, it will start to flash. Enter the code 0000; the selection key flashes more quickly to indicate that the remote control is ready for the search. Point the remote control at the appliance. Press and slowly release the ON/OFF key or PLAY for the VCR and DVD several times, stopping when the appliance responds correctly to the command. When the appliance responds correctly, press OK to confirm. Three flashes indicate that the search operation has been completed correctly. + + + or or 5 SEC. or ADDITIONAL CHECK Check that some of the other functions used on your original remote control are working correctly. If the commands function incorrectly or erratically, you have probably entered a code for a similar remote control but not the right one. In this case, repeat the search procedure starting from point 2. To display and make a note of the code memorized by means of the search, follow the instructions described in the paragraph CURRENT CODE DISPLAY. N. B. The remote control exits programming mode and the light indicator stops flashing: · if no keys are pressed for 14 seconds · if a key other than ON/OFF or PLAY is accidentally pressed · if the end of the code search list has been reached. In this case consult the enclosed CD or the internet site www. meliconi. com/guide 3 CURRENT CODE DISPLAY To find out the code of your remote control, follow this procedure: 1. Hold down the selection key of the appliance whose code you want to know for 5 seconds. When the key is released it will start to flash; press and release the 1-/-- key within 8 seconds. After a few seconds, the light indicator communicates the code you are looking for by flashing the four numbers separately. Count the number of flashes; each series of flashes corresponds to one figure in the code. Make a note of the code on the adhesive label inside the battery cover for quick and easy future reprogramming. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . = 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . = 6 Code obtained = 1306 or or 5 SEC. N. B. this operation cannot be interrupted and the remote control cannot therefore be used until the end of the 4 series of flashes. ENTERING THE CODE If you know the exact code with which to programme the remote control, enter it as follows: 1. [. . . ] If necessary, replace them with 2 new 1. 5 V AAA/LR03 batteries. The appliance does not respond but the selection keys do light up. Check that the batteries are new and that the remote control is pointing at the TV without any obstacles in the way. If required, reset the remote control code, following the programming procedure. The selection keys flash. The remote control commands are not all working correcting. The batteries are low. Reset the remote control code, following the programming procedure. The code for your appliance make is not in the Code Book. To find the code with which to programme your remote control consult the enclosed CD or on-line guide at www. meliconi. com/guide. INFO-LINE If you have any queries about your UNIVERSAL 3-300 remote control: · read this Instruction Booklet carefully - you will find an answer to most of your questions · consult the enclosed CD or our website where you will find the answers you need easily and quickly. WARRANTY: 2 years The warranty ceases to be valid if the product is tampered with or used incorrectly. [. . . ]