User manual MELICONI PRATICO 6

[. . . ] Each original device has a specific code which must be used to set up the remote control. So to use the Pratico 6 you must enter the specific code for each device you wish to control. So use one of the following methods to identify the correct code and set it in your remote control: A) - INTERNET (recommended) B) - CELL PHONE (SMS) C) - MANUAL SEARCH SETTING CODES USING INTERNET If you have an Internet connection available, follow the on-line guide on the www. Com/guide website to identify the specific codes for the devices you wish to command. [. . . ] Or CHECK Check that the other buttons correspond to the functions of the original remote control; if not, it is likely that the code found is incorrect, but is used for a very similar device. In that case, repeat the procedure from point 2. If the manual search for the code is successful, obtain the code in use by following the DISPLAY CODE IN USE procedure and make a note of it inside the battery cover. NOTE: During the search the indicator stops flashing and the remote control exits the programming mode in the following cases: • if for 12 seconds the button indicated is not pressed or if another button is pressed • if the list of codes to find is terminated. Com/guide website 8 ENTERING THE CODE DIRECTLY (only to be performed if you know the specific code to be set) 1. Press and hold down for 6 seconds the device selection button corresponding to the device you wish to enter the code for. Note: Use the PVR button if the device is a VCR. Immediately enter the specific code previously found. Three long flashes indicate a correct setting. If they do not appear, repeat the procedure. If the result is still negative, it means the code indicated is not included in the remote control. (see following section) or or or or 6 SEC. INTERNET UPDATE Today you can download from the internet directly to your remote control the codes of the latest devices or those which will be brought out in future, codes which would not otherwise be available using traditional programming methods. To do this you need to purchase the special MELICONI Audiocable, which allows you to download the information you need onto any PC using an internet connection. DISPLAY CODE IN USE If you set up the remote control using the MANUAL SEARCH procedure, obtain and make a note of the code in use as follows: 1. Press and hold down for 6 seconds the device selection button corresponding to the device you wish to enter the code for. Note: Use the PVR button if the device is a VCR. Press the TV / RADIO button for an instant. After a pause of several seconds, the indicator light produces four sets of flashes, spaced out, corresponding to the code to be obtained. Each set of flashes corresponds to one figure in the code. Make a note of the code obtained on the label on the inside of the battery cover. code obtained = 1306 or or or or 6 SEC. [. . . ] Suitable differentiated collection to allow subsequent recycling of the decommissioned device, with environmentally-compatible treatment and disposal, help to prevent any negative effects on the environment and health and to promote the recycling of the materials of which the device is made. Improper disposal of the product by the user will be subject to the sanctions in Legislative Decree No. U hoeft alleen een SMS te sturen naar het nummer 0039 345 7518893, waarin u de volgende gegevens vermeldt: 6A, type, merk, model - Type = het te bedienen toestel aangeven met behulp van een van de volgende afkortingen: TV - SAT - DVD - VCR - TER (terrestrische decoder) - AUX (ander audio-/videoapparaat). - Merk, model = het merk en model van het te bedienen toestel aangeven. [. . . ]