User manual MELITTA 190

[. . . ] Melitta SystemService Melitta 190 Operating Instructions 1 2 3 4 5 6 7 8 9 520 10 a 11 12 c b 191 M/A = 270 192 M/A = 500 0 34 13 14 15 16 17 520 185 18 193 W = 5 00 197 W = 7 30 34 0 IPX 3 3 GB Description of parts 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 Servicing indicator lamp Operation indicator lamp Quantity selector switch Start button for filtering programme On/Off switch for top warm holder On/Off switch for filtering unit Lid for water container Top warm holder Drip prevention lever Slide-in filter Glass jug Lower warm holder Switch hot water On/off switch for hot water unit Discharge water boiler Temperature limiter Hot water fittings Drip tray Initial operation Always ensure that the machines are placed on an even surface as otherwise exact dosage is not possible. For the initial operation before making the first coffee we strongly recommend to run the machine with water only. The Melitta System and its principle of unpressurized filtering can generally guarantee for a high rate of extraction i. making full use of flavour and aroma substances of the ground coffee. [. . . ] 193 W / 197 W: b Check if the water discharge hose of the machine has been properly connected to the drain pipe on customer’s site. of water out of the boiler via fittings (17) into the 2 ltr. Stir in quick descaling powder (300 - 400 gr. ) with a plastic spoon until the powder is completely dissolved. Remove the cap for emptying the boiler (no. Open fully the draining tap behind the cap by turning it a quarter to the left using the socket spanner provided. The boiler will now be emptied completely into the customer’s drain. Close the draining tap again by turning it as far as possible to the right. Remove the cap of the top covering plate above the water boiler and fill in the prepared solution with the funnel. After letting the machine heat up fpr approx. 5 minutes operate switch (13) and let approx. of water out of the boiler via fittings (17). After the boiler has been filled with water, operate switch (13) and let approx. Switch off the machine again and empty the boiler as described. Repeat rinsing process 3 times, using fresh water each time. As soon as the indicator lamp within switch (13) ceases to burn the unit is ready for operation. Insert the cap of the discharge opening and put the lid back on the boiler again. b b b Switching off the machine b The machine should be switched off overnight and during longer stillstands. b By operating switch (6) the coffee machine unit and the lower warm holder can both be switched off at once. b The top warm holders (8) are switched off with switch (5). b The hot water unit of W-type machines is switched off by pressing switch (14). electric connections and water supply should be switched off if the machine is not to be operated for a longer period of time. b b b b Servicing indicator lamp A defect within the heating system of the water heater (i. excessive build-up limescale) is indicated by the servicing indicator lamp. If this lamp is illuminated the heater is automatically switched off for safety reasons. [. . . ] Amperage Säkring Amp. 230-240 230-240 400-415 2Nȁ 230-240 400-415 3Nȁ Electric Connection (single phase) El-tilkopling i Volts Elektro aansluiting in Volts El-anslutning i. Volt – – 120 120 Hourly Performance Cups/hour-Water Timekapasitet kopper pr. time-vann UUr capaciteit kopjes/uur water (125 ml) Kopp-kapacitet pr time vatten 200 130 260 100 260 Hourly Performance Cups/hour-Coffee Timekapasitet kopper pr. time Kaffe UUr capaciteit kopjes/uur Koffie (125 ml) Kopp-kapacitet pr time Kaffe 32/10 16/7, 5 32/7, 5 16/10 32/7, 5 Capacity Cups/min. [. . . ]