User manual MELITTA BAR-CUBE

[. . . ] : Continuous sound pressure level (Lpa). 9 a) Cleaning the milk area b) Defrosting the refrigerator 9. Customer service contact information 11 11 12 14 Technical changes reserved 5 5. Installation Customer service will set up, install and present the device ready for operation. [. . . ] ❍ Comply with all cleaning , inspection and repair intervals as specified by MELITTA® . Otherwise, safety, functional reliability and durability may be compromised.  Cleaning agents may be a health hazard when swallowed, breathed in and touching the skin. € – no other cleaning agents than those described in these instructions are used. Any information on cleaning agents must be easily accessible also in emergency situations. If you are using the agents recommended by MELITTA®, this information is enclosed with each of the products. € Pull the plug from the outlet in all these cases or trigger the fuse for the circuit. Preparation After the device has been properly set up and connected according to these instructions, you can now prepare it for operation: ❍ ❍ If cleaning is first required, refer to chapter 8 for details. If you have previously moved the device, let it stand still for 2 hours to allow the oil filling to distribute itself uniformly. A) Refilling the milk Use pre-cooled milk - the cooling power is designed to keep items cool but not to cool down warm milk. gB ➀ ➁ ➂ ❍ Open the device door and . Pull out the milk container by approximately one third. Push the cover back and fill the milk into the milk container. When closing the cover, check to make sure that the milk suction hose is immersed in the milk. You may now push the container in the refrigerator and close the door. B) Switching ON / OFF Behind the opened door you will find the on/off switch of the appliance. The appliance should be switched on about an hour before use so that the refrigerator has cooled down sufficiently. Cleaning Clean the device carefully according to the following instructions to maintain the value and hygiene: Warning!When performing the cleaning activities, make sure that the device … is never immersed in water and water is never poured on it and it is never sprayed clean with a hose. Also, do not spray the setup area, for example, with a water hose or high-pressure cleaner. Danger to life from electrical shock may otherwise occur from water entering the unit and touching live parts. The ingredients are hazardous to your health when swallowed and breathed in and irritate the eyes and skin. [. . . ] Preventive maintenance Because of the associated dangers, repairs and preventive maintenance activities may be performed only by the customer service or professionals authorized by the manufacturer for this purpose. Do not dispose of the machine through the domestic waste!Make sure to follow the applicable national and regional legislation and guidelines regarding disposal. First have customer service inspect malfunctions or damages and repair them, if required, before you continue using the device. [. . . ]