User manual MELITTA LOOK IV THERM DELUXE

[. . . ] Connect the appliance only to a properly installed earthed socket. The appliance must always be disconnected from the power Supply when unsupervised and before assembly, disassembly or cleaning. During operation, parts of the appliance such as the steam outlet at the filter become very hot. Avoid touching these parts and avoid contact with hot steam. [. . . ] Hold down the CALC button for longer than 2 seconds. In the factory settings the CALC button flashes briefly four times with the following pauses . You can set the water hardness at three further levels. Each time you briefly press the CALC button the display changes to flashing one, two or three times, each time followed by a pause (. The settings and display are shown in the following table 1. Once you have set the desired hardness level, again hold the CALC button down for longer than two seconds. The light goes off and your settings are saved. Water hardness cannot be programmed while brewing. The last water hardness level chosen remains even after removing the power cable. Ensure that the appliance is connected to the power source. Fill the water tank with the desired amount of water using the therm jug. With the help of the water level GB display on the tank you can choose the correct 85ml coffee per cup, large cup symbol = approx. Close the lid on the water tank and place the therm jug with closed lid in the appliance. Fold a Melitta® filter bag 1x4® at the embossed seam and place it in the filter holder . Press the filter bag into the filter holder by hand, to ensure a good fit. The amount depends on your personal taste. We recommend using 6-8 g of ground coffee per large cup. Swing the filter back into the appliance. With the Melitta® AromaSelector® you can set the taste of your coffee with just one hand: From mild-aromatic ( ) to strong-intensive ( ). The appliance switches off automatically at the latest 15 minutes after being switched on. This avoids unnecessary use of electricity and saves energy. You can of course turn the machine off manually at any time. [. . . ] Within the guarantee period we will correct all device defects that are based on material or manufacturing errors, through repair or replacement of the device at our discretion. Replace parts become the property of Melitta®. Defects that occurred due to improper connection, improper handling, or repair attempts by nonauthorized persons are not covered by the guarantee. The same applies for failure to comply with the use, care, and maintenance instructions as well for the use of consumables (e. [. . . ]