User manual MEMOREX MB2186AOM

[. . . ] · Consult the dealer or an experienced radio/TV technician for help. WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. SAFETY PRECAUTIONS SURGE PROTECTORS: It is recommended to use a surge protector for AC connection. Lightning and power surges ARE NOT covered under warranty for this product. This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. 2 Dear Customer: Selecting fine audio equipment such as the unit you've just purchased is only the start of your musical enjoyment. [. . . ] When they are weak, it will light dim. BATTERY PRECAUTIONS Follow these precautions when using batteries in this device: 1. Use only the size and type of batteries specified. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage to the device. Do not mix different types of batteries together (e. g. Alkaline and Carbon-zinc) or old batteries with fresh ones. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer's directions. ) AC OPERATION To operate the unit using AC power, connect an AC adapter (not included) to an AC outlet having 120V, 60Hz AC only. Plug the small end into the DC 3V jack on the unit and connect the other end into the AC outlet. The batteries are automatically disconnected when the AC adapter is used. CAUTION: When not using AC power, disconnect the AC adapter from the wall outlet by pulling the plug (not the cord). Do not touch the AC adapter with wet hands. Fully insert the plug without exposing any part of the blade. DC 3V z 6 ­ BATTERY INSTALLATION Open the battery compartment and insert two (2) "AA" size batteries (not included) following the polarity diagram. Put the battery compartment cover back into place. POWER SOURCES ­ + + TO PLAY A PRERECORDED MICROCASSETTE TAPE OPERATION 2 1 Press the STOP/EJECT button and insert a microcassette tape with the 1 to be played facing 1 side you and the exposed tape facing the right. Close the Microcassette compartment. Slide the TAPE SPEED switch to the tape speed used when recorded. CONTINUED ON THE NEXT PAGE 7 3 OPERATION (CONTINUED) 4 1 2 Set the VOLUME/VAC Mic Sensitivity control to the desired level. 1 1 Press the PLAY button 1 to begin playback. When finished listening, press the STOP/EJECT button 2 to stop playback. EAR (EARPHONES) JACK For private listening, connect earphones (not included) to this jack. The speaker is automatically disconnected when the earphones plug is inserted in the jack. 8 TO FAST REWIND/REVIEW A MICROCASSETTE TAPE OPERATION (CONTINUED) 2 1 1 2 1 2 To rapidly rewind a microcassette tape in the Stop mode, slide the REW (REV)/F. F switch to the REW (REV) position. Press the STOP/EJECT button when you reach the desired position. To rapidly review a microcassette tape, press the PLAY button and then slide and hold the REW (REV)/F. F switch to the REW (REV) position. You will then hear the microcassette play at fast speed. [. . . ] Adjust the VOLUME/VAC Mic Sensitivity control 3 until your voice activates the recorder; the REC/BATT indicator will light. To stop recording entirely, press the STOP/EJECT button 4. · The first few sounds activate the recorder and may not be recorded. · A variation in voice level during recording will not stop the unit; two seconds of silence is required to stop the recording. · For constant recording, see page 13. [. . . ]