User manual MEMOREX MD3849OM

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. [. . . ] Be sure to follow the correct polarity when installing the batteries as indicated next to the battery compartment. Reversed batteries may cause damage to the device. Do not mix different types of batteries together (e. g. Alkaline, Carbon-zinc and rechargeable) or old batteries with fresh ones. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer's directions. ) AC OPERATION To operate the unit using AC power, connect an AC adapter (not included) to an AC outlet having 120V, 60Hz AC only. Plug the small end into the DC 4. 5V jack on the rear of the unit and connect the other end into the AC outlet. The batteries are automatically disconnected when the AC adapter is used. CAUTION: When not using AC power, disconnect the AC adapter from the wall outlet by pulling the plug (not the cord). Do not touch the AC adapter with wet hands. Fully insert the plug without exposing any part of the blade. DC 4. 5V ­ + 5 + ­ HEADPHONES Connect the stereo headphones (included) to the Phones jack . CD PLAYBACK 1. Slide the CD Door Open switch to open the CD compartment lid. Insert a disc with the label side facing up on to the spindle until it locks in place. While the unit is off, press the PLAY/PAUSE ( ) POWER ON button to start playback. Adjust the VOLUME control to your desired listening level. To pause PLAYBACK, press the PLAY/PAUSE ( ) POWER ON button, the track number will blink in display. To stop playback, press the STOP( ) button once. To turn the unit off, press the STOP( ) again while in the stop mode. Notes: · When the CD door is open, " - - " will appear in the display. · If a disc is in served in correctly, dirty damaged or not present at all, " no" will appear in the display. [. . . ] · Clean the compact disc periodically with a soft, lint-free, dry cloth. Never use detergents or abrasive cleaners to clean the compact disc. · If a compact disc skips or gets stuck on a section of the disc, it is probably dirty or damaged (scratched). B EN ZEN E C LE ANE R · When cleaning the compact disc, wipe in straight lines from the center of the compact disc to the outer edge of the compact disc. · This unit is designed to play only compact discs bearing the identification logo as shown here. [. . . ]