User manual METABO 90 SCS

[. . . ] Declaration of Conformity We, being solely responsible, hereby declare that these jigsaws conform to the standards and directives specified on page 3. ENGLISH en - To extract dust more efficiently, use the protective cap (11) and a suitable Metabo vacuum cleaner together with this tool. - The work place must be well ventilated. - The use of a dust mask of filter class P2 is recommended. [. . . ] - Insert the guide element (6) once more (see section 6. 8 Sawing close to the wall Remove the protective cap (11), anti-splintering footplate insert (8), circular-cutting and parallel guide. These parts cannot be used when sawing close to the wall. - Slacken the screw (19) until the footplate (9) can be raised slightly. - Raise the footplate (9) slightly and slide backwards up to the stop. - Insert the guide element (6) once more (see section 6. Commissioning Before plugging in, check to see that the rated mains voltage and mains frequency, as stated on the rating label, match your power supply. Never operate the machine without a saw blade. Fitting the anti-splintering footplate insert Danger of injury due to the sharp jigsaw blade. Remove the saw blade before fitting (8) the antisplintering footplate insert. Turn the machine over so that the footplate faces upwards. Insert the anti-splintering footplate from the front, ensuring the following: • The smooth side of the footplate faces upwards. €¢ The slot is facing to the rear (towards the mains cable). If you wish to work with the protective plate attached (see chapter Accessories 10. ), fit the antisplintering footplate insert in the protective plate. Sawing with a guiding device for straight cuts (SCS) The metal guide (5) of the guide element (6) dips into the kerf and stabilises the machine to ensure even straighter cuts. Removing the guide element: - Hold the machine with the footplate down. The guide element thus falls out of its retainer in the footplate. (Should the guide element not fall out by itself, you can insert the hexagon spanner (16) into the guide element hole and remove it in this way). Inserting the guide element: For straight cuts, insert the guide element so that the metal guide (5) protrudes under the footplate. For diagonal and curved cuts, insert the guide element so that the metal guide (5) fits into the footplate and is not visible. - With the unlocking key pressed, insert the guide element into the footplate. [. . . ] 100 - 360 mm) and making cuts parallel with edges (max. I) Place the clamping elements (a) on the footplate (9) with the opening facing forwards and the threaded hole facing up. Remove the clamping elements after use otherwise the saw blade clamping fixture (2) may be damaged when diagonal cuts are made. attaching the circular-cutting guide (page 4 , Fig. [. . . ]