User manual METABO HS 8755

[. . . ] Have the machine repaired if braking time is clearly lengthened. Danger of injury from the sharp edges of the blades. Always wear protective goggles, gloves, and suitable shoes when working with the hedge trimmer. Always hold the machine with both hands and stand firmly on the ground. [. . . ] Carry the hedge trimmer by the handle with the cutter blade stopped. When transporting or storing the hedge trimmer always fit the cutting device cover. Proper handling of the hedge trimmer will reduce possible personal injury from the cutter blades. Hold the electric power tool by the insulated gripping surfaces because the cutting blades may come into contact with the cord. Cutting blades contacting a "live" wire may energise metal parts of the power tool, resulting in an electric shock. 7 en ENGLISH be switched off and the plug removed from the socket before the cause of the blockage can be removed manually from the cutting blade. Removing twigs or cuttings), deposit the machine outside the working area. Lay the machine down such that persons are not at risk. When you have laid the hedge trimmer down, pull the plug from the socket. For storage and transportation, always slide the enclosure onto the cutting blades. (It has been slid on correctly if the Metabo lettering faces upwards). Only carry the machine by the bow-type handle. Thanks to the patented Quick stop, the cutting blades come to a standstill within 0. Have the machine repaired if braking time is clearly lengthened. The noise that sometimes occurs during a machine Quick stop is design-related and has no influence on operation and service life. Cleaning the cutting blade (after every use) Before cleaning: Switch the machine off. With a brush or cloth) After cleaning: Treat cutting blade with Metabo hedge trimmer care oil 6. 1 Switch (safety two-hand operation) 2 Switch (safety two-hand operation) 3 Switch (safety two-hand operation) 4 Bow-type handle 5 Hand protection 6 Enclosure 7 Cutting blades 8 Impact protection with twig feed 9 Cable strain relief device 8. maintenance It is advisable to have blunt cutting blades sharpened in a specialist workshop. Check cutting blades regularly for damage and have them repaired in a specialist workshop immediately if necessary. Commissioning Before plugging in, check to see that the rated mains voltage and mains frequency, as stated on the rating label, match with your power supply. To prevent the hedge trimmer plug from inadvertently being pulled out of the coupling socket of the extension cable, attached the extension cable to the cable strain relief device as shown (9) (Figure on page 2). [. . . ] measured values determined in conformity with EN 60745. Machine in protection class II ~ Alternating current The technical specifications quoted are subject to tolerances (in compliance with the relevant valid standards). Håll i de isolerade handtagen eftersom det finns risk att knivarna i svärdet kan komma i kontakt med sladden till maskinen. For å unngå at støpselet til hekksaksen utilsiktet trekkes ut av koblingsboksen til skjøteledningen, bør skjøteledningen plasseres i innretningen for kabelstrekkavlastningen (9) som vist på bildet (illustrasjon side 2). [. . . ]