User manual METABO SBE 850

[. . . ] Juli 2009 1:54 13 ENG ENGLISH Original instructions Dear Customer, Thank you for the trust you have placed in us by buying a Metabo power tool. Each Metabo power tool is carefully tested and subject to strict quality controls by Metabo's quality assurance. Nevertheless, the service life of a power tool depends to a great extent on you. Please observe the information contained in these instructions and the enclosed documentation. [. . . ] Tighten the side handle in the required angle depending on the task at hand. Impact and twist drilling can be done only with a clockwise direction of rotation. 6 Selection of direction of rotation (not for SB 660) Loosen the side handle (16). Set depth stop (4) to the desired drilling depth and retighten the side handle. 2 Switching on/off To start the machine, press the trigger (13). The speed can be changed at the trigger (not SB 660). Due to the electronic soft start the machine accelerates continuously up to the pre-selected speed (SBE 1010 Plus, SBE 85, SBE 850 Impuls, SBE 850 Contact). For continuous operation the trigger can be locked with the lock button (11). To stop the machine, press the trigger again. If switched on continuously, the machine continues running if it is jerked out of your hands. Therefore, always hold the machine with both hands on the handles, stand safely, and concentrate on your work. 3 Speed preselection (not for SB 660) Do not actuate the rotation selector switch (14) unless the motor has completely stopped. Select direction of rotation: R = clockwise L = counter-clockwise The drill chuck must be firmly screwed onto the spindle and the safety screw inside the drill chuck (if applicable / modelspecific) must be firmly tightened with a screwdriver. When screwing) it could otherwise become loose. 7 Tool change with Futuro Top keyless chuck (3) a Pre-select the max. See page 4 for recommended drilling speeds. 4 Gear selection Select the desired gear by turning the control knob (5). Change gears only with the machine coming to a complete standstill (start and switch right off again). Grip the retaining ring (a) firmly and, with the other hand, turn the sleeve (b) against the stop. To open the drill chuck grip the retaining ring 14 17026951_0709 SB_Bauk. Juli 2009 1:54 13 ENGLISH (a) firmly and turn sleeve (b) in the opposite direction. 8 Tool change with Futuro Plus keyless chuck (2) a ENG Removing the tool: Open the geared chuck with the chuck key and remove tool. [. . . ] SBE 85, SBE 850 Impuls: When the machine is switched on, if the thumb-wheel (9) is turned from pulse function to torque control, the machine will switch off automatically. Switch the machine off and then back on again. Juli 2009 1:54 13 ENGLISH Electronic signal indicator (10) (SBE 1010 Plus) Rapid flashing - restart protection When power is restored after a power failure, the still switched-on machine does not start for safety reasons. Slow flashing - carbon brushes worn The carbon brushes are almost completely worn. [. . . ]