User manual METABO SBE900

[. . . ] The head of the screw may rip off or high restoring torques may be incurred at the handle. Dust from material such as paint containing lead, some wood species, minerals and metal may be harmful. Contact with or inhalation of the dust may cause allergic reactions and/or respiratory diseases to the operator or bystanders. Certain kinds of dust are classified as carcinogenic such as oak and beech dust especially in conjunction with additives for wood conditioning (chromate, wood preservative). [. . . ] G Position 1-6: The motor comes to a complete stop when the preselected torque is reached. 1 = low torque 6 = high torque + = no torque control (max. Torque, for drilling) = impulse function switched on constantly (to facilitate tightening and releasing of screws that are tight even when the screw heads are damaged. To enable clean drilling without centre punching in tiles, aluminium or other materials). H See the table for recommended rotational speeds for drilling. A: With the trigger Continuous operation (13) pressed, push in the locking button (12) and release the trigger. Press and release the trigger (13) again to switch off. In continuous operation, the machine continues running if it is forced out of your hands. Therefore, always hold the machine with both hands using the handles provided, stand in a safe position and concentrate. tool change , Futuro Top keyless chuck (6) Fig. I Clamp the tool by turning the sleeve firmly to its stop. tool change , Plus (5) keyless chuck Fig. J The ratchet sound which can possibly be heard after opening the drill chuck is functional and is switched off by a reverse rotation of the sleeve. If the chuck is very tightly closed: Firmly grip the chuck with an open-end spanner at the chuck head and firmly turn the sleeve in the direction of the arrow -1. Clamping the tool - Insert the tool -2- as far as possible. Keep turning the sleeve (it must "click" when turning) until it cannot be turned any further - only now is the tool safely clamped. With a soft tool shank, retightening may be required after a short period of operation. Initial Operation Before plugging in the device, check to see that the rated mains voltage and mains frequency, as specified on the rating label, match your power supply. To guarantee secure purchase of the chuck: After initial drilling (clockwise), use a screwdriver to firmly tighten the safety screw inside the drill chuck (if available/depending on the model). B For safety reasons, always use the additional handle supplied. Tighten the additional handle firmly by turning it. D Do not activate the rotation selector switch (11) unless the motor has completely stopped. [. . . ] This prevents the further unauthorized heating of the motor. Use only accessories which fulfil the requirements and specifications listed in these operating instructions. For a complete range of accessories, see www. Repairs Repairs to electrical tools must be carried out by qualified electricians ONLY! [. . . ]