User manual METABO STA 18 LTX

[. . . ] Declaration of Conformity We declare under our sole responsibility: These cordless jig-saws, identified by type and serial number *1), comply with all relevant requirements of the directives *2) and standards *3). Specified Use The machine is suitable for sawing non-ferrous metals and sheet steel, wood and similar materials, plastics and similar materials. The user bears sole responsibility for any damage caused by improper use. Generally accepted accident prevention regulations and the enclosed safety information must be observed. [. . . ] 6 Sawing without dust extraction - Work with the protective cap (5) removed (see Removal chapter 7. C Remove the protective cap (5), the protective plate (2), anti-splintering footplate (3) and extraction connection piece (11). These parts cannot be used for diagonal cuts. - Slide the footplate (10) back slightly and turn. - You can read off the angles from the scale (21). Adjust to different angles using an angle gage. - Push the footplate (10) forward in the angles provided until it engages. 8 Battery pack Charge the battery pack before use (14). if performance diminishes , recharge the battery pack. The ideal storage temperature is between 10°C and 30°C. Figures Illustrations are provided at the beginning of the operating instructions. 31213)* 2 Protective plate for use with sensitive tool surfaces (attach as shown) * 3 Anti-splintering footplate insert * 4 LED lights 5 Protective cap * 6 Protective rod for preventing unintentional contact with the saw blade 7 Adjustment lever for pendulum motion 8 Switch button on the chip blower 9 Sliding on/off switch 10 Footplate 11 Extractor connection piece * 12 Setting wheel for speed adjustment 13 Battery pack release button 14 Battery pack 15 Capacity and signal indicator 16 Capacity indicator button 17 Saw blade 18 Saw blade support roller 19 Saw blade clamping fixture 20 Clamping lever for securing the saw blade 21 Scale for reading off the cutting angle 22 Clamp lever for diagonal cuts 23 Locking screw 24 Clamping force screw * depending on equipment/not in scope of delivery 7. Remove the saw blade before fitting the antisplintering footplate insert (3). Turn the machine over so that the footplate faces upwards. Insert the anti-splintering footplate from the front, ensuring the following: • The smooth side of the footplate faces upwards. € The slot is facing to the rear (towards the battery pack). If you are working with the protective plate attached (2) (depending on fittings), fit the anti-splintering footplate insert in the protective plate. 10 ENGLISH en - Press the button (16); the LEDs indicate the charge level. (15) - (15)If one LED is flashing, the battery pack is almost flat and must be recharged. 9 Removing or replacing the battery pack Fig. A To remove: Press the battery pack release (13) button and pull the battery pack (14) upwards. To fit:Slide in the battery pack (14) until it engages. [. . . ] Switch it on again and continue to work as normal. avoid any additional overloading or jamming. The LED (4) is flashing quickly and the machine is not running. The machine will not start if the battery pack is inserted while the machine is on. [. . . ]