User manual METABO STE 90 SCS

[. . . ] Follow national requirements for the materials you want to work with. During work, the workpiece must lay flat and be secured against moving, e. Do not try to saw extremely small workpieces. When sawing, the footplate must make secure contact with the workpiece. [. . . ] The saw blade is now securely tightened). 4 Attaching / Removing the protective cap Attachment: Push on the protective cap (11) from the front until it engages Removal: Grip both sides of the protective cap (11), lift slightly, then pull forwards and remove. 5 Sawing with dust extraction - Connect a suitable extraction device to the extractor connection piece (18). Use a suction hose with a 30 mm connector diameter. - Attach the protective cap (11) for maximum extraction efficiency. 6 Sawing without dust extraction - Work with the protective cap (11) removed (see Removal chapter 6. These parts cannot be used for diagonal cuts. - Then slide the footplate (9) forwards or backwards and engage in one of the detents (the detents can be viewed through the semicircular opening at the rear of the footplate (9). ) The preset angle is indicated on the curved support plate (20) on the footplate. Adjust to different angles using an angle gage. - Insert the guide element (6) once more (see section 6. 2 ENGLISH en - Insert the guide element (6) once more (see section 6. Apply a drop of oil to the saw blade support roller (3) from time to time. 1 Chip blower Optional blower for a clear view of the cutting line. On: press in the switch button (14) on the right side of the machine. Off: press in the switch button (14) on the left side of the machine. 2 Adjusting the pendulum motion Set the required pendulum motion using the adjustment lever (13). The best way to determine the ideal setting is through a practical trial. 3 Setting maximum speed Set the machine to maximum speed using the setting wheel (17). see page 3for recommend setting values. The best way to determine the ideal setting is through a practical trial. 4 On/Off switch, continuous activation Avoid inadvertent starts: always switch the tool off when the plug is removed from the mains socket or if there has been a power cut. [. . . ] 100 - 360 mm) and making cuts parallel with edges (max. I) Place the clamping elements (a) on the footplate (9) with the opening facing forwards and the threaded hole facing up. Remove the clamping elements after use otherwise the saw blade clamping fixture (2) may be damaged when diagonal cuts are made. attaching the circular-cutting guide (page 4 , Fig. [. . . ]