User manual METABO SXE 425

[. . . ] General Safety Instructions For your own protection and for the protection of your electrical tool, pay attention to all parts of the text that are marked with this symbol!WARNING – Reading the operating instructions will reduce the risk of injury. wARNING Read all safety warnings and instructions. Failure to follow all safety warnings and instructions may result in electric shock, fire and/or serious injury. [. . . ] - For replacement support plates, refer to the Accessories chapter. - Mount support plate (2) and rotate until it engages on carrier disc. - Insert locking screw (15) again and tighten. Replacing support plate brake / braking ring If the idling speed of the support plate increases in course of time, the braking ring (16) is worn and must be replaced. ) is being sanded, the braking ring inevitably wears faster. - Use the hexagon spanner (10) to unscrew the fixing screw (15) on the support plate. - Replace the old braking ring (16) with the new braking ring (see Chapter on Accessories), ensuring that the new braking ring is in the same position as the old braking ring. Ensure that the position of the marking on the braking ring is correct. - Mount support plate (2) and rotate until it engages on carrier disc. - Insert locking screw (15) again and tighten. You can choose between two oscillating frequency settings: • Oscillating circuit high setting (6. 2 mm): coarse sanding with high material removal rate • Oscillating circuit low setting (2. - Rotate support plate (2) in a counter-clockwise direction until you can hear it engage. - Continue turning the support plate half a revolution to the next snap-in point. 2 On/Off switch, continuous activation To start the machine, press the trigger switch (8). For continuous operation the trigger switch can be locked using the lock button (7). To stop the machine, press the trigger switch (8) again. 3 Setting oscillating frequency When the TurboBoost switch (6) is switched off, the oscillating speed can be set at the setting wheel (5). 3-4 Coarse and fine sanding, polishing, wood 5 The best way to determine the ideal setting is through a practical trial. 4 TurboBoost switch Actuate the TurboBoost switch (6) during operation to switch on additional power reserves for maximum material removal rate. 5 Dust extraction To optimise the dust extraction performance, fit the sanding disc such that the holes on the sanding disc (1) are aligned to the support plate (2). Own extraction system: Fit the dust collection box (12) onto the exhaust nozzle until it engages. [. . . ] It may be used for a preliminary assessment of exposure. The declared vibration emission level represents the main applications of the tool. However if the tool is used for different applications, with different accessories or poorly maintained, the vibration emission may differ. This may significantly increase the exposure level over the total working period. [. . . ]