User manual METABO W18LTX

[. . . ] Declaration of Conformity We declare in our sole responsibility: These angle grinders, identified by type and serial number *1), comply with all relevant requirements of the directives *2) and standards *3). ENGLISH en can be attached to your power tool, it does not assure safe operation. D) The rated speed of the accessory must be at least equal to the maximum speed marked on the power tool. Accessories running faster than their rated speed can break and fly apart. [. . . ] The risk from these exposures depends on how long you or bystanders are being exposed. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as dust masks that are specially designed to filter out microscopic particles. Observe the relevant guidelines for your material, staff, application and place of application (e. Occupational health and safety regulations, disposal). Collect the generated particles at the source, avoid deposits in the surrounding area. Use suitable accessories for special work (see chapter 11. ), thus less particles enter the environment in an uncontrolled manner. Inform yourself of the currently valid specifications when shipping li-ion battery packs. If necessary, consult your freight forwarder. certified packaging is available from Metabo. Only send the battery pack if the housing is intact and no fluid is leaking. Remove the battery pack from the machine for sending. Prevent the contacts from short-circuiting (e. Initial Operation Attaching the additional handle Always work with the additional handle attached (15)!Attach the additional handle on the left or right of the machine and secure. 2 Install safety guard For safety reasons, always use the safety guard provided for the respective wheel!Safety guard for grinding Designed for work with grinding wheels, flap sanding pads, diamond cut-off wheels. Place the safety guard (16) in the position indicated. - Release the lever and turn the safety guard until the lever engages. - Pull on the (19)lever and turn the safety guard until the closed section is facing the operator. - Make sure that the guard is seated securely: the lever must engage and you should not be able to turn the safety guard. Use only accessories that are covered by at least 3. [. . . ] Permitted thickness of accessory M = Spindle thread l = Length of the grinding spindle n = No-load speed (maximum speed) P1 = Nominal power input P2 = Power output m = Weight (with the smallest battery pack) Measured values determined in conformity with EN 60745. Direct current The technical specifications quoted are subject to tolerances (in compliance with the relevant valid standards). Emission values These values make it possible to assess the emissions from the power tool and to compare different power tools. Depending on the operating conditions, the condition of the power tool or the accessories, the actual load may be higher or lower. [. . . ]