User manual METRONIC ACCESSBOX

[. . . ] User guide DIGITAL SATELLITE RECEIVER 4000 channels / Parental Control 2 Scarts / DiSEqC 1. 2 CAUTION Your AccessBox has ventilation slots. These slots must not be obstructed, even partially, in order to ensure proper ventilation. The lifetime and normal functioning of your device depends on these factors. The device may not be exposed to dripping or splashing and no object filled with liquid, such as vases, must be put on the device. [. . . ] You will find these parameters in specialised magazines, which provide a monthly update, or on dedicated websites (www. satcodx. com, www. lyngsat. com, . . . ) To add channels from a transponder, do the following steps: · Go into MENU / INSTALLATION / CHANNEL SEARCH. · On the line SATELLITE press OK to display the satellites list. · With the CH keys, select the satellite, which emits the channel, to be added then press OK. · On the line SEARCH MODE, leave MANUAL. · On the line FREQUENCY, type the 5 figures of the transponder frequency. · On the line SYMBOL RATE, type the 5 digits of the symbol rate (SR); · Check that the level is green, which means that you entered the correct parameters. · On the line NETWORK SEARCH, if you choose ON the search may continue on other frequencies if the operator broadcasts parameters of linked transponders. · On the line FTA / SCRAMBLED, choose FTA to save space, by not putting in memory scrambled channels that you can't watch. · Press OK to launch the channel search. The window CHANNEL SEARCH lists the TV and radios found. The new channels will be added to the end of the channel list. Automatic channel search · Go into, in MENU / INSTALLATION / CHANNEL SEARCH · On the line SATELLITE, press OK to display the satellites list. · With the CH keys, select the satellite, which emits the channel to be added, then press on OK. · On the line SEARCH MODE, choose AUTO. · On the line FTA / SCRAMBLED, choose FTA · Press OK to launch the channel search. The window CHANNEL SEARCH appears and lists the TV and radios found. B Note: in the AUTO search mode, the receiver will search channels from each transponder it has in memory for the concerned satellite. If a channel is not found, and you are sure that it exists, it may be because you need to update the transponders list. (see next paragraph) C Add / Delete / Edit a transponder · Go into MENU / INSTALLATION / SAT/TRANSPONDER EDIT · In the lefthand column, select the satellite with the CH keys. · Press to go to the righthand column and select the transponder to be edited or deleted. · Press OK to show the action-selection window. · To delete the transponder, choose DELETE TP, press OK and confirm YES. The entire transponder channel will be erased. [. . . ] · Where did you install your satellite kit?On a balcony On the roof (chimney. . . ) On the wall On the ground Other. . . . . . . . . . . . . · Which cable lenght did you use?5m 10 m 15 m 20 m 30 m 40 m plus · Other remarks or suggestions: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]