User manual METRONIC VIDEO SENDER

[. . . ] The garland has 4 «beads», 3 for the devices, and 1 for the main TV. 6 - Adhesive patches to fix the beads on the front panel of the sources. 7 - AC/DC adapters (x 2) 8 - Scart leads (x 2) to link the transmitter to the main TV and the receiver to the secondary TV. [. . . ] 5 - Plug one of the AC/DC adapters to the rear of the transmitter. 4 0 208 994 11 81 6 - Put the channel selection switch on position «1» 7 - Push on the « « button of the transmitter, the red light turns on. 8 - Switch on your main TV and then switch on all the sources connected to the transmitter. Put your TV in A/V mode to view the signal from the default source. Usually, this is done by pressing the 0/AV key, or EXT, or AUX, . . . In case of problem, please refer to the user manual of your TV. 9 - By pressing each one of the 4 bottom buttons (PRI) of the provided remote control, check that you can see any of the connected sources. B Setting up receiver 10 - Link the receiver and the secondary TV with the provided scart lead 11 - Switch on the SEC TV and put it in AV mode. The screen should be black 12 - Plug the AC/DC adapter on mains and connect it to the receiver. 13 - Put the channel selection switch on position «1» 14 - Press the « « button on the receiver, the red light should turn on and the programme from the transmitter should appear on the secondary TV. If not, make sure that all the sources from the main TV are on, as well as the transmitter. 15 - By pressing each one of the 4-buttons remote control, check that you can select any source from the distant room. If the picture is not OK, try to move the receiver to a better location (a few inches may sometimes do the trick). In case of no other location is found suitable, try another channel on BOTH transmitter AND receiver. 0 208 994 11 81 5 3 C Installing the remote extender 16 - For each device that you want to control from the distant TV, search for the location of the infrared sensor. 17 - Plug the garland into the IR port of the receiver and find the path for the garland that will allow to put a bead in front of each device. 18 - Stick the beads on the devices with the provided adhesive patches. 19 - Bring the original remote controllers of all the devices near the receiver, in the distant room. For each device, select the source with the 4-buttons remote control and check that you may control the device from the distant room. [. . . ] If its orange, it means this source is also sent to the main TV. 6 TROUBLE SHOOTING · The screen of the ·Put the TV in AV mode (key EXT, 0/AV, AUX, ). · The screen of destination · Check that the transmitter is ON TV stays black (or blue). · In case of multi scart TV, check that you selected the right AV input. [. . . ]