User manual METZ 20 TK 51

[. . . ] The remote control handset may not operate correctly if the TV set is exposed to direct sunlight, because the TV set is not able to detect the infra-red signals. The TV set must be switched on with its main switch before the remote control handset can be used. Do not point the remote control handset at your eyes and press any of the buttons on it!100 programmes from VHF, UHF bands or cable channels can be preset. [. . . ] Child Lock You can use this feature to prevent children turning on/off TV or changing programmes or adjustments etc. When Off is selected, there will be no difference in the operation of your TV. When On is selected, the TV can only be controlled by the remote control In this case the control panel buttons except " will not work. To enter the Installation menu directly, press the Blue ( ) button, or Press "MENU" button, now you are in main menu. When any item is selected with or button in the install menu, the selected item will be highlighted on the bottom bar. Changes by pressing or button will be result only at highlighted item on the bottom bar. Selecting Programme To select programme number, you can use or button, Digit Buttons or The Double Digit button with digit buttons. You can select sound that comes from TV, AV-1, AV-2 or AV-3 to hear in PC mode. Selecting Band Band, can be chosen either, C or S by or - 48 button. Selecting Channel Channel can be changed by or button, by Digit Buttons or by the Double Digit button with digit buttons. Selecting Search To start the search process, press button for forward search or button for backward search. the selected mode comes automatically on the screen. This OSD is displayed when the "DoubleDigit" button pressed in place of the programme number indicator. After then, in order to enter a programme it must be pressed to two digit consecutively. When it is late to press any digit button this function will be ignored and the display will be erased. In the same way it must not be late to press any digit button after entering the first digit. Passed then TV goes automatically to standby. It is placed in the upper middle of the screen when enabled, and it stays there until it is disabled. This indicator is displayed under the programme number indicator on the screen. Dual I is selected in default and also can be selected after Dual II by Remote Control. To cancel mute, there is two alternative; the first one is pressing to " " button, this volume is set to the preceding value, and the second one is increasing the volume level, thus it starts at the minimum level to increase. By decreasing the volume level in mute state, mute will not be ignored, only the volume level will decrease. [. . . ] Use the stereo headphone socket on the back side of your TV, to connect headphones. Connect your camera or camcorder at the back side of your TV. Connect your equipment to the TV via SVideo input at the back side by using SVideo cables. The following table is an illustration of some of the typical video display modes. [. . . ]