User manual METZ MECABLITZ 48 AF-1 OLYMPUS

[. . . ] Mode zoom manuel Avec les appareils photo qui ne transmettent pas de données concernant la distance focale de l'objectif, vous devez adapter manuellement la position du zoom du réflecteur principal à cette distance focale. Zoom automatique En cas d'utilisation du flash avec un appareil photo qui transmet des données concernant la distance focale de l'objectif, la position du zoom du réflecteur principal s'adapte automatiquement à cette distance focale. 79 Table 1: Guide numbers at maximum light output (P 1) . 121 Table 3: Recycling times and number of flashes with different battery types . [. . . ] mecabounce 58-90 If the Mecabounce 58-90 (optional accessories , see 17) is fitted to the main reflector of the flash unit , the main reflector is automatically guided to the position required. The distance data and zoom factor are corrected to 16 mm. At the same time, one or more slave flash units can be remotely controlled from one master or controller flash unit on the camera (e. A slave flash unit can be assigned to one of three possible slave groups (GROUP A, B or C). The master or controller flash unit can control all of these slave groups simultaneously and at the same time take the settings for each slave group into account. So that multiple remote systems in the same room do not interfere with one another, there are four independent remote channels available (CH 1, 2, 3 or 4). Master, controller and slave flash units belonging to the same remote system must be set to the same remote channel. The slave flash units must be able to receive the light from the master or controller flash unit with the integrated sensors for the remote mode .  Depending on the camera model, the camera's internal flash unit can also function as master or controller flash unit. Please consult the respective camera operating instructions for further tips on setting the master or controller flash unit. After about 5 seconds the display stops flashing and the setting is saved automatically. after activation of the remote slave mode , , , SL " appears in the display. In addition, the slave group (GROUP) selected and the remote channel (CH) are shown. Setting of the slave group With the remote slave mode activated, press the button combination , , Select" until , , GROUP" (= slave group) flashes in the display. After about 5 seconds the display stops flashing and the setting is saved automatically. after activation of the remote slave mode , , , SL " appears in the display. In addition, the slave group (GROUP) selected and the remote channel (CH) are shown. With the remote slave mode activated, press the button combination , , Select" until , , CH" (= remote channel) flashes in the display. After about 5 seconds the display stops flashing and the setting is saved automatically. after activation of the remote slave mode , , , SL " appears in the display. In addition, the slave group (GROUP) selected and the remote channel (CH) are shown. Use flash unit mounting foot W-F127 to set up the slave flash unit. [. . . ] The camera does not transfer data to the flash unit · There is no exchange of data between the flash unit and the camera. In close-up shots, overexposure (shots that are too bright) may result if the shutter speed is faster than the flash sync speed. The minimum distance from the subject should be at least 10% of the maximum flash range indicated on the display. Guide numbers at ISO 100/21°, zoom 105 mm: In the metric system: 48 In the imperial system: 157 Flash modes: Standard TTL with measuring preflash, TTL­HSS, Manuel, M-HSS Manual partial light output levels: 1/1 . [. . . ]