User manual METZ MECABLITZ 48 AF-1_CANON

[. . . ] Zoom automatique En cas d'utilisation du flash avec un appareil photo qui transmet des données concernant la distance focale de l'objectif, la position du zoom du réflecteur principal s'adapte automatiquement à cette distance focale. Mode zoom manuel Avec les appareils photo qui ne transmettent pas de données concernant la distance focale de l'objectif, vous devez adapter manuellement la position du zoom du réflecteur principal à cette distance focale. - Lorsque «S ON» s'affiche à l'écran, la fonction « zoom size » est activée - Lorsque «S OFF» s'affiche à l'écran, la fonction « zoom size » est désactivée. 86 Table 1: Guide numbers at maximum light output (P 1) . [. . . ] So that multiple remote systems in the same room do not interfere with one another, there are four independent remote channels available (CH 1, 2, 3 or 4). Master, controller and slave flash units belonging to the same remote system must be set to the same remote channel. The slave flash units must be able to receive the light from the master or controller flash unit with the integrated sensors for the remote mode .  Depending on the camera model, the camera's internal flash unit can also function as master or controller flash unit. Please consult the respective camera operating instructions for further tips on setting the master or controller flash unit. After about 5 seconds the display stops flashing and the setting is saved automatically. after activation of the remote slave mode , , , SL " appears in the display. In addition, the slave group (GROUP) selected and the remote channel (CH) are shown. Setting of the slave group With the remote slave mode activated, press the button combination , , Select" until , , GROUP" (= slave group) flashes in the display. After about 5 seconds the display stops flashing and the setting is saved automatically. after activation of the remote slave mode , , , SL " appears in the display. In addition, the slave group (GROUP) selected and the remote channel (CH) are shown. At the same time, one or more slave flash units can be remotely controlled from one master or controller flash unit on the camera (e. A slave flash unit can be assigned to one of three possible slave groups (GROUP A, B or C). The master or controller flash unit can control all of these slave groups simultaneously and at the same time take the settings for each slave group into account. With the remote slave mode activated, press the button combination , , Select" until , , CH" (= remote channel) flashes in the display. After about 5 seconds the display stops flashing and the setting is saved automatically. after activation of the remote slave mode , , , SL " appears in the display. In addition, the slave group (GROUP) selected and the remote channel (CH) are shown. Use flash unit mounting foot W-F127 to set up the slave flash unit. Wait for all of the flash units involved to become flash ready. Once the slave flash units are flash ready, the AF measuring beam will blink. [. . . ] The subject contains very bright or highly reflective areas. In close-up shots, overexposure (shots that are too bright) may result if the shutter speed is faster than the flash sync speed. The minimum distance from the subject should be at least 10% of the maximum flash range indicated on the display. There is an exchange of digital data between the flash unit and camera. [. . . ]