User manual METZ MECABLITZ 50 AF-1 DIGITAL

[. . . ] Mode zoom manuel Avec les appareils photo qui ne transmettent pas de données concernant la distance focale de l'objectif, vous devez adapter manuellement la position du zoom du réflecteur principal à cette distance focale. Zoom automatique En cas d'utilisation du flash avec un appareil photo qui transmet des données concernant la distance focale de l'objectif, la position du zoom du réflecteur principal s'adapte automatiquement à cette distance focale. 104 Table 1: Guide numbers at maximum light output (P 1) . 160 Table 3: Recycling times and number of flashes with different battery types . [. . . ] In this process, the flash of the controller flash unit has a control function for the slave flash units, and does not itself contribute to any significant extent to lighting the shot. The slave flash units must be able to receive the light from the controller flash unit with the integrated sensor for remote mode . The camera settings for RC remote mode can be found in the camera's operating instructions. In addition, the slave group (GROUP) selected, the remote channel (CH) and the reflector position (Zoom) are shown. In remote mode, the AF measuring flash of the mecablitz flashes as soon as the flash-ready indicator lights up. As the mecablitz digital only supports TTL und manual M flash modes, automatic flash mode A must not be selected on the camera in RC mode for the slave flash unit. If automatic flash mode A is selected for the slave flash unit on the camera, the slave flash unit will not flash when the photograph is taken. Use the + and -- buttons to make the required setting. 5 seconds the indicator stops flashing and the setting is memorised automatically. The slave flash unit can be assigned to one of three possible groups (A, B or C). Each of these groups may consist of one or more slave flash units. setting the slave flash unit (mecablitz) · With the remote slave mode activated, GROUP B press the button combination "Select" until GROUP B "GROUP" (= slave group) flashes in the display. Use the + and -- buttons to make the required setting. To ensure that several remote systems used in the same room do not interfere with one another, four independent remote channels (CHANNEL 1, 2, 3 or 4) are available. With the remote slave mode activated, CH 2 press the button combination "Select" until "CH" (= remote channel) flashes in the display. Use the + and -- buttons to make the required setting. 5 seconds the indicator stops flashing and the setting is memorised automatically. after activation of the remote slave mode , "SL" appears in the display. In addition, the slave group (GROUP) selected, the remote channel (CH) and the reflector position (Zoom) are shown. 5 seconds the indicator stops flashing and the setting is memorised automatically. after activation of the remote slave mode , "SL" appears in the display. In addition, the slave group (GROUP) selected, the remote channel (CH) and the reflector position (Zoom) are shown. [. . . ] The minimum distance from the subject should be at least 10% of the maximum flash range indicated on the display. Guide numbers at ISO 100/21°, zoom 105 mm: In the metric system: 50 In the imperial system: 165 Flash modes: Standard TTL with measuring preflash, TTL­HSS, Manuel, M-HSS Manual partial light output levels: 1/1 . 460 with lithium batteries (at full light output) Recycling time (at full light output): Approx. Light coverage: Main reflector from 24 mm (35 mm format) Main reflector with wide-angle diffuser from 18 mm (35 mm format) Swivelling ranges and locking positions of the reflector upwards -7° 45° 60° 75° 90° counter-clockwise 30° 60° 90° 120° 150° 180° clockwise 30° 60° 90° 120° Dimensions, approx. [. . . ]