User manual METZ MECABLITZ 58 AF-1 DIGITAL SONY

[. . . ] Il est possible d'adapter la valeur de la distance affichée à la distance au sujet en modifiant l'ouverture du diaphragme ou la puissance partielle. 105 Table 3: Guide numbers at maximum light output (P 1) . 161 Table 6: Recycling times and number of flashes with different battery types . We are happy to welcome you as a customer. [. . . ] Shorter shutter times than the flash sync time can be set on the camera in remote operation only if the slave flash unit is not mounted on the camera and the camera is set to Remote Mode "WL" (wireless). Setting the remote channel To ensure that several remote systems used in the same room do not interfere with one another, four independent remote channels (CHANNEL 1, 2, 3 or 4) are available. Press the "Para" key repeatedly in activated Remote Mode until only "CHANNEL" (= Remote channel) and the Remote channel appear on the display. Use the ( + ) and ( - ) buttons to make the required setting. If the "Return" key is not pressed, the display will automatically switch back to SLAVE after approx. Setting the controller flash unit (camera) The remote channel is automatically set on the controller (camera's integrated flash unit) when data is transferred if the slave flash unit is mounted on the camera and the camera's shutter release is actuated.  The remote channel can only be selected and set on the slave flash unit, In TTL Remote Mode, manual flash correction can be set to adjust light output: · Press the "Para" key repeatedly until only "TTL" is displayed (if a correction value has already been set it will also be displayed). Use the ( + ) and ( - ) buttons to make the required setting. Possible manual correction values are from -3 EV to +3 EV in 1/3 step increments. Once the partial light output has been set, "TTL" and the manually set flash correction value are displayed. In Remote Mode Manual M, a partial light output can be manually set to adjust the light output: · Press the "Para" key repeatedly until only "M" and the manually set partial light output appear. Use the ( + ) and ( - ) buttons to make the required setting. The setting can range from P 1/1 (full light output) to P 1/256. Once partial light output has been set, "M" and the light output set are displayed. Use the flash unit mounting foot W-F127 (special accessories; see 17) to support the slave flash unit. Wait until the slave flash unit and the camera's integrated flash unit are ready If the slave flash unit is not flash-ready, its AF meter flash starts flashing. If the slave flash unit does not trigger a test flash, correct the position of the slave flash unit to enable it to receive the light sent by the controller flash unit or reduce the distance between the controller and slave flash units. Once successful test flash operation has been checked, you can now start taking the shots. The secondary reflector i is used for frontal brightening in the case of indirect lighting when the main reflector is pivoted to the side or upwards (see 10. If the secondary reflector produces too much light, it can be reduced to 1/2 or 1/4 . When the secondary reflector is activated and the setting is saved, a symbol will appear in the display. Press the , , Return" button repeatedly until the display is reset to its normal state. [. . . ] S) The camera's f-stop and ISO values are not displayed and cannot be manually set on the flash unit. Digital data is automatically exchanged between the flash unit and camera. F-stop and ISO values are displayed in Automatic A and Manual M Modes if the flash unit is not operated on the camera, i. The values can now be manually changed, e. [. . . ]