User manual METZ MECABLITZ 76 MZ-5 DIGITAL

[. . . ] En modifiant la valeur de diaphragme ou la puissance partielle, vous pouvez adapter la valeur de distance affichée à la distance par rapport au sujet. Voor de TTL-flitsfunctie is het instellen van de diafragmawaarde op de flitser alleen voor het correct weergeven van de reikwijdte, echter niet voor het correct functioneren vereist!Voor de TTL-flitsfunctie is het instellen van de ISO-waarde op de flitser alleen voor het correct weergeven van de reikwijdte, echter niet voor het correct functioneren vereist!76 Operation with NiMH battery pack 76-56 . [. . . ] With the bleep function the user can have some device functions of the flash unit conveyed acoustically. In this way the photographer can concentrate fully on the subject and shot and need not pay attention to additional optical status displays!The bleep function acoustically indicates when the flash is ready, the correct flash exposure or an incorrect setting. Acoustic signal after the flash unit is switched on: · 2 second) uninterrupted bleep signal immediately after the shot indicates that the latter was correctly exposed and that flash readiness remains available. If no bleep signal immediately follows the shot, the photograph was under-exposed. An intermittent bleep signal immediately after the shooting is the signal for a correctly exposed flash light shot. The flash readiness continues, but only after a subsequent (approx. A short bleep as an acoustic alarm is generated in the auto flash mode if the aperture and ISO setting would exceed the permissible light control range. In stroboscopic flash mode the flash number (N) per shutter release can be set. The number of flashes can be set from 1 to 50 in single increments. The flash frequency can be selected from 1 to 50 in single increments. The special functions are selected with the button "Sel" (Select). Depending on the camera system (manufacturer), camera type and SCA adapter, various special functions can be selected. Select the menu point or special function required with the Up / Down buttons . The menu point selected will be highlighted with a dark bar. Press the button "Set" and so confirm the choice of the special function. A series of flash exposures (flash bracketing FB) can be carried out in the flash modes TTL and auto A flash modes. A flash bracketing series consists of three successive flash shots with different flash exposure correction values. When setting a flash bracketing series, FB and the correction value are shown in the display. The first shot is taken without a correction value. The second shot is taken with a minus correction. The third shot is taken with a plus correction. [. . . ] To change the slave address, switch off the slave flash unit for approx. Number of flashes (in each case at full light output): · approx. 160 with Metz NiMH battery pack 76-56 · approx. 270 with Metz Power Pack P76 Recycling times (in each case with full light output): · approx. [. . . ]